Operation Guide 0.9GHz Wireless Baby Monitor Kit Model No.: 8209SB The graphics included are subject to minor change without notice.
3. Structure 3-1. Structure of Camera 3-2.
4. Installation 4-1. Installation of Camera 4-1-1. Basic installation of Camera 1. Locate the camera to a specific position. 2. Connect the camera to the adapter and then slide the power switch to ON position. Note: (This camera can also use dry battery as power supply. Please load 4 AA batteries to the battery compartment at the back of camera with their polarities matched. @The AC adapter will work instead of batteries after iris plugged.
3. Rotate the rounded head of camera to a suitable angle for surveillance. 4-1-2. Camera channel setup 1. Check out the right side of the camera and there is the channel switch marked as CH1, Ch2. Each of them can be selected separately for the purpose of the multi-camera working situation or interference avoidance. 2. Press channel button of the receiver to select the same channel as the camera, The pictures will be displayed on the screen. Chl: 908MHz Ch2: 922MHz 4-1-3.
Sensitivity Alarm Alarm sound volume is adjustable Motion Alarm Setup: Motion Alarm refers to the alarm against various movements. To set up motion alarm slide the alarm switch to Motion position and select Sensitivity level. The system enter motion alarm mode stand-by for changes or movements to occur in order to trigger the alarm. When movement is detected, the alarm begins to sound for 2 minutes until the Eliminate Alarm button is pressed to snooze for 35 seconds.