WNA699U8G.1 USB DONGLE User manual Ver: 1.
Contents Chapter 1 Introduction ............................................................................... 1 Product Outline....................................................................................... 1 Applications ........................................................................................... 1 Compliance Certificates.......................................................................... 2 Feature.............................................................................
Chapter 1 Introduction The WNA699U8G.1, a Wireless Local Area Network(WLAN) 802.11 b/g USB dongle, by inserting a PC USB socket and connecting a wireless access point through wireless interface, can provide the transmission of broadband data service. It is suitable for using in a wide range of both residential(at-home) and commercial (offices, apartments, hotels, warehouses) network applications. It gives you a blazing fast connection to the internet, far fast and more convenient. The WNA699U8G.
• Broadband internet access • Audio and video streaming and transfer • PC file and application sharing • Network and online gaming Compliance Certificates • FCC Class B • CE Mark • Wi-Fi Certification Feature • USB 1.1/2.0 interface • Comply with IEEE802.11 b/g • Support 64/128-bit WEP, 802.1x, WPA, and WPA2 for wireless security • Support 802.11e wireless multimedia Qos • Support 802.
Chapter 2 Driver Installation You should install the driver by the following steps: Step 1: Double-click the installation file(.exe), then it pops the installshield wizard. You should read and accept the license agreement to continue the installation and then click “next”. Step 2: Then select the setup type that best suits your needs. by default, select “ralink configuration tool” and then click “next”.
Step 3: Then choose configuration Txburst or WiFi. By default, you should select “optimize for WiFi mode” and then click “next”. Then the installation begins. Step 4: It takes about 20seconds to complete the installation and then click “finish”. Now you could insert the USB dongle—of course, you could also insert it before executing the installation file, and then a ralink icon appear at the right corner of the PC， .
could see the RaUI. The nearby available wireless networks with their basic information would be listed in this interface. The USB dongle would automatically connect to the one which has the strongest signal and without encryption. However, you could also select the desired one and click “connect” to establish connection with it. The blue triangle before the SSID of the AP signifies a successful connection between the USB card and the AP. Click “rescan” to renew the list.
Note 2: if the DHCP function of the server or AP is enabled then you needn’t config the IP address of your PC. Otherwise, you need manually config the IP address of your PC in the same range with the AP. Note 3: if you want to uninstall the hardware in your PC, double-click the installation file(.exe) again and select “remove all” in the popped interface to remove it. Note 4: to learn more about the application of the USB dongle, please consult about the appendix. WNA699U8G.1 RaUI_使用说明.
This device must not be co-located or operating in conjunction with any other antenna or transmitter NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. Federal Communications Commission (FCC) Requirements, Part 15 This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
