User's Manual

USER MANUAL FOR FT0309HD REMOTE CONTROL TRANSMITTER

I. Operation Instructions

1. ON/OFF the Fan



When fan shut down, press this button, the fan run at the speed before fan shutdown.

 When fan are on, press this button, the fan shut down.

2. Breeze Mode: Between Speed 2 to Speed 4, at 40 seconds in a curve and circle speed. Reach one specific

speed, it changes to another speed.

3. Speed of the fan (1~6 level)



The "+" key increases the fan gear. The higher the gear, the higher the fan speed.



The "-" key lowers the fan gear, and the lower the gear, the lower the fan speed.



The number of indicators displayed corresponds to the current fan gear.



The lowest gear is 1st gear and the highest gear is 6th gear.

Direction of the fan

ON/OFF the fan

LED inditor

Speed

the

fan

FT0309HD transmitter

Timer

Breeze Mode

PAGE 1
USER MANUAL FOR FT0309HD REMOTE CONTROL TRANSMITTER I. Operation Instructions LED inditor Breeze Mode ON/OFF the fan Speed of the fan Timer Direction of the fan FT0309HD 1. transmitter ON/OFF the Fan  When fan shut down, press this button, the fan run at the speed before fan shutdown.  When fan are on, press this button, the fan shut down. 2. Breeze Mode: Between Speed 2 to Speed 4, at 40 seconds in a curve and circle speed. speed, it changes to another speed. 3.
PAGE 2
4. Fan timing control Set up the timer at 2hours,4hours ,6 hours. 2H press this key, the fan will stop after 2 hours. 4H press this key, the fan will stop after 4 hours. 6H press this key, the fan will stop after 6 hours.  The timing function of the key works when the fan is running. Press the key “+”or”-” will cancel the timer. The latest timer will take place the previous one.  The number of LED lights corresponds to the number of hours when the fan is shut down. 5.
PAGE 3
 IC Caution: RSS-Gen Issue 5 "&" RSS-Gen numéro 5 - English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.