User's Manual

Wireless Door Sensor
Working with Vimtag cloud IP camera, RFC1 is a wireless door sensor which could
detect the opening and closing of the doors and windows. It sends an alarm signal to
the camera when it detects over 3 cm position offset between the signal transmission
module and the magnetic box. Users could receive the alarm message on Vimtag
application, and take immediate action to stop the intruders.
Introduction
Installation Guide
Add Device
CAUTION
Specifications
Step 1: Stick the Transmission module and the Magnetic box on the door or the window,
keeping them at a distance of 2 cm or less.
Step 2: Close and open the door or window to see if the red light on the transmission
module is on. If the light is on, installation succeeded.
Please make sure you have added cameras
to your account before adding the accessories.
Adding Procedure:
1. Log in to your account
2. Enter the Settings interface of the camera
3. Select Accessory
4. Select Door Senor
5. Follow the APP instruction to complete adding.
RF Perpheral RF Perpheral
Battery model: CR2032
Service life: 2 years
Power: 12dBm
Voltage: 2.7V-3.3V
Working Distance: 80M
Temperature: -10℃~55℃
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by tur ning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. This device
complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.