User's Manual

Wireless Flash Trigger User Manual (PT-04ⅡRX)

1. Main parts of receiver of PT-04ⅡRX

(1) The L-bracket is aluminum

(2) Power switch

(3) LED indication light

(4) Channel Selector

(5) PC socket

(6) Hot shoe socket

(7) Battery cover

2. Introduction

The PT-04 Transmitter emits a wireless radio signal to the Tetra PT-04 Receiver when the shutter

is triggered which, in turn, fires the flash using selective channel. This allows you to take pictures

with off-camera flash and not have to depend on your built-in flash as the trigger device.

3. Features

1) Radio frequency

2) Wireless control

3) Low frequency triggering

4) Not harm to cameras

5) Isolated channel selection

6) Independent channel works separately without interference

4. Specifications

1) Receiver battery type: AAA 1.5V x 2 Batteries

2) not-working current: 0uA, working current: 1mA

3) Receiver with PC sync socket

4) flash sync cord with 3.5 mm jack plug plus a 6.3 mm jack adapter

5) Operating distance: 30m (100ft) in open area

5. Operating Instructions

PAGE 1
Wireless Flash Trigger User Manual (PT-04ⅡRX) 1. Main parts of receiver of PT-04ⅡRX (1) (2) (3) (4) (5) (6) (7) The L-bracket is aluminum Power switch LED indication light Channel Selector PC socket Hot shoe socket Battery cover 2. Introduction The PT-04 Transmitter emits a wireless radio signal to the Tetra PT-04 Receiver when the shutter is triggered which, in turn, fires the flash using selective channel.
PAGE 2
A. for use of speed light flash 1) Put 2 AAA batteries into the receiver and close the battery cover 2) Plug the flash into the receiver’s hot shoe socket, and fix it; turn on the power of receiver and flash 3) Set the channel selectors of both transmitter and receiver at same position, and transmitter can send signal to receiver to trigger the flash B. for use of studio flash light 1) Put 2 AAA batteries into the receiver and close the battery cover 2.) You can use the 3.