Users Manual

Table Of Contents

Learning to the radio receiver

Press once the learn button on your radio receiver device to allow reception of a new code. While the receiver is in

the receive new code mode,transmit one of the keypad default codes.Eg.11< or 22> wait until the receiver exits

the reception mode beforetrying the code again.

PAGE 1
Learning to the radio receiver Press once the learn button on your radio receiver device to allow reception of a new code. While the receiver is in the receive new code mode,transmit one of the keypad default codes.Eg.11< or 22> wait until the receiver exits the reception mode beforetrying the code again.
PAGE 2
6) Forget combinations & Battery replacement A hidden factory setting button is reserved for you to restore the factory setting combinations “11" & “22". (※ Note: In order to ensure the safety of the device, the serial number of this device will be automatically updated after restoring the factory settings, and it needs to be re-registered by the receiver to work). 1. Use a tool to pry open the cover here Battery cover Factory setting hole 2. Remove these two screws 3.
PAGE 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.