User's Manual

User Manual

1、Sensor Overview

The sensors use a tire pressure monitoring system (TPMS), to form a system

with the car's tire pressure receiving unit, you need to install the tire wheels (as

shown).

2. Instructions for use

In stationary mode, the pressure and acceleration are measured about every 30

second and emission of RF frames occurs only if pressure variation, higher than a

threshold, is detected (leakage detection).

When the vehicle starts moving, the Tire Guard transmitter enters the driving

mode. Then the wheel unit measures and transmits data every 60 seconds.

If, during any measurement period in driving mode, the pressure leakage is

detected (difference compared to the last transmitted pressure value), a alarm

signal will occur taking in account the latest pressure value emitted as reference

value. If the pressure continues changing, an additional transmission will be sent.

3. Technical Description

Carrier frequency: 433.92 MHz

Number of channels: 1

Method of frequency generation: PLL

Type of modulation: ASK or FSK

Rated Output Power: < 10 mW

Antenna: Integrated antenna

Voltage supply: Lithium battery 3V

Voltage supply range: 2.1V up to 3.3V

PAGE 1
User Manual 1、Sensor Overview The sensors use a tire pressure monitoring system (TPMS), to form a system with the car's tire pressure receiving unit, you need to install the tire wheels (as shown). 2. Instructions for use In stationary mode, the pressure and acceleration are measured about every 30 second and emission of RF frames occurs only if pressure variation, higher than a threshold, is detected (leakage detection). When the vehicle starts moving, the Tire Guard transmitter enters the driving mode.
PAGE 2
4. Warning Statement This equipment has been tested and found to com ply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.