Users Manual

ManualsBrandsSHENZHEN F&G ELECTRON ManualsComputers & AccessoriesWireless Mouse

1.Wireless Main Features:

Wired and 2.4G wireless dual mode with USB+TYPE-C paracord

cable

Best ergonomic design for long comfortable play in gaming

Best Grip for every style play

RGB led turn on/off function with switch and software

Easy and quick DPI change with DPI button on top

Sensor: PMW3335

Custom software

Polling Rate:125-250-500-1000Hz

300mA rechargeable lithium battery

Type-C Wired connection and charging

Charging indication in the wheel

Low Packet Loss Rate in a variety of operating environments

Zero delay with 1000Hz polling rate(1MS response time)

Low power consumption with 3 levels power management

Software synchronous for both USB wired and 2.4G wireless

Auto-detaction between wired and wireless

Size:120x66x42mm

Weight:94g with battery

Summary of content (5 pages)

PAGE 1
.Wireless Main Features: Wired and 2.
PAGE 2
PMW3335 SENSOR PARAMETER ITEM Parameter Battery ca pacity Power:3.7VDC, MCU:3.3VDC, sensor:2.1V 300mA lithium battery Current(Al l led off m ode) Remark Standby 2(s top 10 seco nds) Standby 2(st op 1 minute s) Sleep(Stop 9 minutes) Mode Workin g Standby1 (Stop) 125Hz 4.5mA 2.8mA 2.3mA <45uA <45uA 250Hz 5.5mA 2.8mA 2.5mA <45uA <45uA 500Hz 7.5mA 3mA 3mA 2.6mA <45uA 1000H z 11.5mA 11mA 4.6mA 4.
PAGE 3
Mouse instruction: Mouse installation 1.Take out the wireless USB Nano receiver from bottom of the mouse 2.Plug the receiver into your computer USB port 3.Turn on the mouse power by switching the power switch on the bottom of the mouse 4.Waiting for computer installation finished DPI setting and indication 1.DPI level: 400-800-1200-2400-3200-6400,total 6 levels DPI 2.By pressing the DPI button on the top of mouse to change DPI circularly 3.
PAGE 4
Note: 1.Switch at LED off place: turn on the mouse power, but RGB led is off 2.Switch at power off place: turn off the mouse power 3.Switch at led on place: turn on the mouse power and RGB led 4.If you switch from power on to RGB led on directly, you need stop at power off place for at least 1 second to make sure the LED can be turned on properly 5.
PAGE 5
FCC Warning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.