MT-303 Transmitter MT-303TX Operating Instructions MT-303TX Cover N CH2 Reverse CH3 N R CH1 Hi R CH2 EPA CH3 R Lo CH2 CH1 D/R
Up CH2 CH1 Down D/R upward downward MT-303TX Up CH2 CH1 D/R Down downward MT-303TX upward Up CH2 CH1 D/R Down MT-303TX upward downward N Reverse R R CH1 Hi CH2 CH2 EPA N N R CH3 R Lo CH3 MT-303TX N Reverse N R CH1 Hi R CH2 CH2 EPA N R CH3 R Lo CH3 MT-303TX N Reverse R R CH1 Hi CH2 CH2 EPA N R CH3 Lo CH3 MT-303TX Hi CH2 EPA Lo Lo Hi
Receiver MT-303RX Operating Instructions MT-303RX N CH2 Reverse CH3 N R CH1 Hi R CH3 CH2 EPA R Lo
Receiver MT-302RE Operating Instructions Connects to the steering servo MT-302RE Switch Battery connector Motor connector Antenna Wire LED Indicator MT-303TX & MT-302RE Bind Step 1: Power off both transmitter and receiver. Step 2: Turn on receiver. The LED indicator on the receiver will begin to flash. MT-302RE MT-302RE Step 3: Turn on the transmitter. The transmitter and receiver will now bind automitically within the next 2 seconds.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.