Quick Operation Guide

Wireless Charger

FCC ID:2A33Q-EWC1M001

01/Usage method

1. Insert the USB-C plug of the wireless charger cable into the adapter with the corresponding interface, ensure that

the adapter works normally.

2. Put on the wireless receiving position of the power receiving equipment directl

on the charging panel of the wireless charger for wireless charging; the useo

coupling ring is helpful for the correct alignment of the equipment and can obtai

more experience.

3. When charging finished, remove the power receiving equipment from the wireles

charger.

02/Safetytips

1. Please ensure that there are no metal objects between the power receiving equipment and the product, which may

cause the product to not work and potential safety risks.

2. Do not store magnetic stripe cards (such as bank cards, bus cards, telephone cards, etc.) or some medical

equipment (such as pacemaker or hearing aid, etc.) together with this product, which may cause magnetic stripe

damage, abnormal operation of the equipment, etc.

3. Do not apply heavy pressure on this product and keep it out of the reach of children or animals.

4. Donotdisassemble,refitandrepairbythe user itself. The risks and losses arisen therefrom shall be borne by the

user itself.

03/ Attention

1. It is recommended to use it with adapters that support fast charging protocol above pd2.0 and output power

greater than 20 watts, so as to give full power output of this product and ensuretheuseexperience.

2. When using this product to charge, please put on the power receiving equipment correctly in the wireless

charging area. Incorrect placement will lead to problems such as reduced charging efficiency, heating, disconnection

of charging, etc.

PAGE 1
Wireless Charger Quick Operation Guide FCC ID:2A33Q-EWC1M001 01/Usage method 1. Insert the USB-C plug of the wireless charger cable into the adapter with the corresponding interface, ensure that the adapter works normally. 2. Put on the wireless receiving position of the power receiving equipment directly on the charging panel of the wireless charger for wireless charging; the use of coupling ring is helpful for the correct alignment of the equipment and can obtain more experience. 3.
PAGE 2
3. During wireless charging, the distance between the center point of the wireless charging area of the power receiving equipment and the upper surface of the product shall not exceed 4mm, and there shall be no metal objects in the contact surface of the wireless charging panel. 4. It is recommended that when wireless charging is carried out, the ambient temperature shall not be higher than 28 ℃, and excessive ambient temperature will reduce the charging efficiency.
PAGE 3
—Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user's authority to operate the equipment.