Quick Installation Guide

01. Put in the CD and find windows file “windows
(xp,vista,win7,win8,win10)” andSetup.exe.
02. Double click Setup.exe file, Software begin to
initialization,then click the “Next”.There shows the
installation progress.
03. Do not interrupt installation, Click “finish” to finish the
driver installation.The computer automatically restart.
Wireless connection (two ways to realize
Wireless connection 1：
04.Plug the Wireless USB Adapter into the USB port of
your PC
05.Click Icon in the Windows system tray, which
locates in the bottom-right corner of your computer screen
or double click , and pops up a message and
click”Available Network” Double-click the utility icon or right
click the icon ,and the Wireless Network Connection
window appears then double click the SSID you preferred.
1 2 3 4 5
Note：This Manual based on Windows7
802.11AC Dual-Band
Wi-Fi USB Adapter
Quick Installation Guide
6
7 8 9
10 11 12 13
Note:if there is no icon
, please find it in the right
buttom,it have been hide as following
pictures shows:
Wireless Connection2.
06. Click Icon which locates in the bottom-right
corner of your computer screen,click the wireless network
list and choose the SSID you preferred. and double click
(Or click “Connect”).
Type the encryption key and then click “ok”.
Type the encryption key that you wrote down
earlier in both the Network key and Confirm
network key boxes, and then click “ok”.
Before a new model adapter is a available for sale to the
public, it must be tested and certified to the FCC that it
does not exceed the exposure limit established by the
FCC, Tests for each adapter are performed in positions
and locations as required by the FCC.
For body worn operation, this adapter has been tested and
meets the FCC RF exposure guidelines when used with
an accessory designated for this product or when used
with an accessory that contains no metal and that
positions the adapter a minimum of 5 mm from the body.
FCC Statement
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV
technician for help.
Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating
positions accepted by the FCC with the adapter
transmitting at its highest certified power level in all tested
frequency bands, although the SAR is determined at the
highest certified power level, the actual SAR level of the
adapter while operating can be well below the maximum
value, in general, the closer you are to a wireless base
station antenna, the lower the power output.
Model: EP-AC1601