Installation Instructions

2.4G Wireless Keypad
B038
CE Statement
Herby,Shenzhen DZH Industrial Co., Ltddeclares that this 2.4G Wireless
Keypad，B038 is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU. In accordance with Article 10(2)
and Article 10(10), this product allowed to be used in all EU member states.
Use the 2.4G Wireless Keypad in the environment with the temperature
between -20℃ and 60℃
Operation Frequency: 2408MHz ~ 2474MHz
Max output power: -4.86dBm
Manufacturer：Shenzhen DZH Industrial Co., Ltd
Address：3th Floor, YiTuo Mike Industrial A building, Bu Yong Industrial D
zone, ShaJing, Shenzhen, China
Tel: [phone]
Fax: [phone]
E-mail: [e-mail]
The product shall only be connected to a USB interface of version USB2.0
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1)this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.