User's Manual

L L1 L2
User Manual
1 2 3
N
L
L L1 L2
N
L
N N1
L L1 L2
N
L
Ac input
90~260V
L L1 L2
li ght2
Control b ox 2
li ght3
N N1
+
1 2 3
654
Model name
Plastic material ABS(UL94-V0 & Rohs)
AC Input power Ac90 260V
AC Output power < 500W
DC Input power DC12V/300mA(±1V)
DC Output power < 150W
Standby power < 0.13W
Receiving Frequency 433MHz
Receiving range 20～50m
Application environmen Indoor+Shield (-30 60deg)
~
7
Wireless controller
Notice to Users
●It requires professionals with electrician operation
qualifications to do the installation.
●It is forbidden to install the controller in a place where it is
easy for people to touch.
●Besides preparing various tools before installation, you
also need to read the installation precautions in detail.
●After unpacking, please do not place the product in the
hot,humid,dusty and greasy place for a long time.
●There is a lifespan for the remote control battery.If you find
that you need to press the switch multiple times to make it
work,it means that the battery is insufficient and you need to
replace the battery with the same specification.
Installation Precautions
①The power supply should be cut off before installing
the controller to avoid electric shock.
②The wire interface must be connected correctly.
③The controller should not beinstalled inplacesnear to
heat source, high-frequency transformer, or magnet, so
as not to affect its normal use.
④If the controller is installed on the top of the ceiling, fix
it with the bottom facing upwards.
⑤If the controller is installed in a metal box, the
receiving antenna needs to be led out of the metal shell
with a piece of wire, and the exposed length is not less
than 30cm.
⑥This controller cannot be used beyond the load power
(normally less than 500W is appropriate).
⑦The wiring ports are connected according to L, L1, L2,
N, N1 (refer to the figure).
Installatin diagram(1)
Operational Settings
1.After connecting the controller wiring port and power on,
press the button on the controller, if the light will turn on once
and then go out, it means that the controller is working
normally and is in the standby state;
2.The remote controller and the controller are paired with
devices (a controller can support 20 remote control
commands)
①Single-channel controller: Press the button on the
controller twice, wait for the red light to turn on, and then
press the button on the remote control, if the pairing is
fine,the light will immediately go out;
②Two-way controller : L1 operates according to method
① L2 setting: press the button on the controller 3 times,
wait for the red light to turn on, and then press the
button on the remote control, if the pairing is fine, light
will immediately go out;
③Two-way controller : Press the button on the controller 4
times, wait for the red light to turn on, and then press the
button on the remote controller, the light will go out
immediately if the pairing is fine.This mode is the L1+L2 two-
way synchronous opening or synchronous closing.
④If the setting is unreasonable and the buttons need to be
redistributed, press the key of the controller 8 times to clear
the setting parameters.
~
Parameter
Installatin diagram(2)
Installatin diagram(3)
li ght1
Control b ox 1
Ac input
90~260V
Ac input
90~260V
Control b ox
li ght2
li ght1
Control b ox
li ght