User's Manual

Component
AV Dock Station
for iPod&iPhone
Power
USB power input:5V DC 1A
AV Dock Station output power:5V DC 1A, or 5V DC 500mA
Compatibility
WarningThank you for buying our product. Before operating this product,
Please read the manual in detail for proper operation of the
AV Dock Station for iPod&iPhone
1. AV Out
a),Plug the red, green, and blue video connectors into the component
video input(Y,Pb and Pr) ports on your TV or receiver, Plug the write and
red audio connectors into the left and right analog audio input ports
respectively, on your TV or receiver. Plug the mini HDMI connectors of
component AV cable into AV Dock Station.
b), Put the Dock plate suitable for iPhone/iPod into the groove of the
Using
AV Dock Station Remote Control
Component AV Cable
Mini USB Cable
the Dock Station, and insert the iPhone/iPod into the Dock Station
to ensure that the Apple 30 pin connector of the Dock Station is
duly connected to iPhone/iPod connector.
c), then you can enjoy the relaxing time with the remote control.
The Kit Includes：
Component dock station x1
(inclueds iPhone4 plate X1, iPod touch/iPhone 3GS plate x1)
Remote control x1
1M Mini USB cable x1
1.5M Mini HDMI/5RCA cable x1
iPhone 4 Plate
iPod Touch /
iPhone 3GS Plate
3. How to change the plate?
POWER
MENU
ENTER
MUTE
REPEAT
SHUF
VOL+
VOL-
Component AV Cable
2. Charging & Sync
Connect AV dock station to USB power adapter and plug Apple
device into the dock for charging.
Connect AV dock station to computer for charging and sync via the
mini USB cable .
4. Important Notice
To remove iPhone/iPod,side the
iPhone&iPod in an upward motion
Never pull your iPhone/iPod
towards you to remove
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Do not modify, disassemble, open, drop, crush, puncture or shred the product
Do not expose the product to rain or water
Keep away from open flame or sunlight to prevent heat build-up
Keep away from high voltage devices
This product is not a toy, keep away from children. Insure that all persons who use
the product read and follow these warnings and instructions.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.