Assembly Instructions

ManualsBrandsShenZhen Deftun Technology ManualsElectronicsSmart lock

Table Of Contents

Smart lock Manual

Door handle

Safety switch

Screw holes

Key hole Mortise 5050

USB

Fingerprint area

IC Card area

Code area

Led linght

Battery cover

IC card

Buckle box

Buckle Plate

Mortise lock

1PC1

1PC

2PC

Quantity

Picture

Accessories

Item

2PC

Quantity

Picture

AccessoriesItem

Screw

Connecting rod

Square pole

Key

1PC

2PC

Door thickness

Determine the door direction

Suitable to 35mm ~ 70 mm thickness door.

When a person stands outside the door and opens the door

with his left hand, that means choosing the left open.

People who open the door with their right hand choose right open.

Left open Right open

Change lock body direction

When installing the lock body ,the latch bolt is on the

upper side,the dead bolt under the latch bolt,and the

inclined surface of the latch bolt is facing the opening direction.

1 Reserve the lock body and latch bolt is down(refer to picture 2)

2 Push the latch bolt lower than front plate,stopblock is down and

rotate 180 degrees (refer to picture 2)

3 Push the latch bolt into hole (refer to picture 3)

Accessories

Product details

Technical parameters

1 please refer template carefully to drill hole

2 If there is a deviation in the hole,the mortise and panel assembly are put into.

the door and the hole is corrected until appropriate.

Cutting template

Any password, fingerprint, and IC card can be opened before leaving the factory (the length of the

password is 6-8 digits), which is to facilitate user experience.

The temporary administrator password when leaving the factory is: 123456

Add fingerprint: Press the fingerprint 5 times, and the angle of the fingerprint is as different as possible

each time, and enter the fingerprint on one finger into the system as much as possible.

Fake password: For example: the correct password is 112233, we can enter 5566 112233 5566 when

unlocking, (5566 is a false password at this time, in order to prevent others from remembering your

password.)

is the reverse, is the confirm. After the system setting is completed, you can press to return or

wait for the system to exit automatically.

Summary of content (3 pages)

PAGE 1
Smart lock Manual Accessories Item Led linght Battery cover Code area IC Card area Fingerprint area Picture Accessories Quantity Item 1 Mortise lock 1PC 5 Key 2PC 2 Buckle Plate 1PC 6 Square pole 1PC 3 Buckle box 1PC 7 Screw 2PC 4 IC card 2PC 8 Connecting rod 2PC Picture Accessories Quantity Door thickness Door handle Door handle Suitable to 35mm ~ 70 mm thickness door.
PAGE 2
INSTALLATION SMART LOCK 8 INSTALLATION STEPS 1. Dig holes in the door according to the drawings. 4 6 2. Put Mortise in the door. Strike box 3. Fix Moritse with screws. 5 Strike Plate 7 4. Install the connecting rod on the lock. 5. Insert the square pole into Mortise. 1 6. Put the spring into the rear handle. 7. Tighten the 2 long screws.
PAGE 3
FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.