Bluetooth Keyboard FCC ID : PD8X501 Model:X501,X502,X503,X504,X505,X506,X507,X508,X509 User’s Manual
Usage Instructions: 1. Place your iPad in the Bluetooth keyboard. 2. Turn on your Bluetooth keyboard. The On/Off switch is located on the bottom right side of the keyboard. On/Off Switch *The built-in lithium battery supports 120 hours of continuous typing when fully charged. *Please charge the keyboard with the included USB cable. *For first time use, please charge for 12 hours. After first time use, charging usually takes about 4 hours.
4. When “Bluetooth Keyboard Case” shows up on your list of Bluetooth devices, select it to begin pairing. 5. Enter the password shown on the blue window and press “Enter” on the keyboard. *Pairing is only needed for the initial setup. After your first successful connection, the keyboard will connect automatically to your iPad when powered on.
+ Language Switch + C Copy + V Paste + X Cut + Z Redo + To the top of the text + To the end of the text + Delete the whole line Shift + Select text rightward Shift + Select text leftward Shift + Select text upward Shift + Select text downward Specifications: Bluetooth: Operation Current: Standby Current: Operation Voltage: Charging Voltage: Battery Type: Charge Time: Version 3.0 <1.5mA <0.5mA 4.
Troubleshooting: If you are unable to connect the keyboard to your iPad, please try the following: z Check if the battery is low. When the battery is low, your keyboard will not function properly. Please recharge the battery. z Check the power switch and make sure it is on. When powered on, the power light on the bottom right of the keyboard will flash for two seconds z Restart Bluetooth, and make sure your iPad can find this device z Ensure the password for pairing is correct.
IMPORTANT REGULATORY INFORMATION This device complies with Part 15 of the FCC Rules: Operation is subject to the following two conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference that is received, including any interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.