FREECAST Receiver CP 3 039 User Manual
RX:CP3039 Antenna WIFI indicator Low batter y indicator Reset Key OLED display screen Mini Hdmi in Power Key USB Power Supply Socket channel switch Paining Key Batter y Compartment
Freecast APP installation Please scan the QR code as below or search “Freecast ” APP in APP store. Please note! Please note that the Freecast installedIphone / IPad CPU model requires A7 and above, and the operating system version requires iOS 8.0 and above. That the lithium batter y installed in the opposite direction will cause the product to fail to power on,but will not cause damage to the product. Batter y charge Both the transmitter and receiver use Model No. 14500 cylindrical lithium batter y.
Here is the installation instructions for connect the transmitter to Gopro5 as following: 2. The side cover with screw hole will be fixed after putting the Gopro Hero 5 into its frame. 1. Remove the side cover of the Gopro Hero 5,then install the side cover with screw holes which provided with this product. 3. Insert the Micro-HDMI male connector with screw lock into the Miro-HDMI female base of Gopro Hero 5. Then put the HDMI screw into the screw hole of the side cover and tighten it.
Notification! Please prepare another matching HDMI cable when the camera is Mini-HDMI or standard HDMI interface. 2. When viewing video via a TV or a monitor, the receiver will re-connect with the transmitter if you short press the【channel switch】key on receiver, and the TV or monitor screen will be stuck and then blank .The image will be restore after about 40 seconds, please be patient. WIFI connection of Transmitter and receiver 1.
Push flow and broadcast via Iphone or ipad The kit allows you push the audio & video stream from the transmitter via the 4G network of iphone or ipad (WiFi+Cellular) to Youtube, Facebook and other online live platforms in real time, and you can set up that via Freecast App. Please enter into the “Stream” page of the App for streaming setting.
Case 2: When the receiver needs to be restored the default Wi-Fi password, it needs to be re-paired with the transmitter (as to the detailed operation instruction, please see above). Case 3: The transmitter and the receiver need to be re-paired if anyone is replaced in case of loss or damage. The following is the operation of the transmitter and receiver pairing: 1.