GPS Vehicle tracker User Manual (Version 1.0) This user manual has been specially designed to guide you through the functions and features of your GPS vehicle tracker.
1.Start Guide 1.1 Accessories ◆ Main device ◆ Power cord ◆ 4-pin relay ◆ 5-pin relay*2 ◆ Microphone ◆ SOS cable ◆ Extension cable ◆ Speaker 1.
1.3 Specifications Frequency GPRS Operating Voltage Location Time Storage Battery Location Accuracy Operating Temperature Dimension Weight GSM 850/900/1800/1900MHz Class 12, TCP/IP 9-36VDC / <300mA Cold Start: <35s Hot Start:<2s 64MB 800mAh <10 meters -20℃ ~ +70℃ 83(L)×76(W)×18(H)mm 95g 2.My Device 2.
3. Wire Connection 3.
3.
Wiring Instruction 1.The standard power supply ranges from 9V to 36VDC. Please use the power cord manufactured by the original factory. Red line means positive side while black line means negative side. During installation, negative side should connect to the ground, do not connect with other ground wires at the same time. 2.ACC line (orange) connects to vehicle's ACC switch, detecting ignition on and off. 3.Device's oil and electricity control line (yellow) connects to relay's 86.
3.3 Device Installation Under rear windshield Device Under front windshield Device Device Around dashboard Note: The device should face up to the sky. Metal thermal barrier or heating layer of the windshield affects the signal. Please change installation places to receive better signal. 4. Operation of device Power on/ Power off Power on: Once you insert a valid SIM card and connect all the wires, turn on the device. Power LED will flash first.
5. Main Functions 5.1 SOS In emergent case, press SOS for 3 seconds to activate SOS alarm. Then the device will send SOS SMS to preset SOS numbers and then dial the numbers in a loop for 3 times until the call is picked up. Alarm message will also send to platform. (See command list 7-9) 5.2 Power cut-off alarm When the electricity supply of device is cut off, it will activate cut-off alarm. 5.3 Low batter y alarm When battery is low, the device will activate low battery alarm.
Notice 1.Pre-set SOS number is necessary. Non-SOS number cannot activate this function. 2.SIM card of device must have caller ID sevice. 5.6 Two-way communication To activate this function, ensure that both MIC and speaker are connected well. Use pre-set SOS number to dial the device, after 10 seconds, device enters into two-way talk mode. 5.7 Displacement alarm(default OFF) Device will send movement alarm when vehicle moves out the preset distance (when ACC is off and GPS is fixed). 5.
5.9 Restore oil/electricity When alarm is all-clear, you can send restore oil/electricity command by platform, APP or SMS and restore vehicle power. (See command list 7-16) 5.10 Restart device If GPRS is abnormal (device is offline), user can send SMS command RESET# to restart the device. Device will reboot after 20 seconds after receiving the command. (See command list 7-17) 5.11 Door detection The device is able to detect door status. It uploads car status to platform and APP timely.
5.13 Find the car by triggering light and buzzer When need to pick out the car parking on giant parking lot, you can send a command. After the device receives the command, it will control turn light relay or horn relay by the yellow line of extended port, so as to trigger the car's light or horn. In this way, you can figure out your car's position easily and accurately. See 3.3 diagram-3 for wiring way. (See command list 7-20) 6.
7.Common Command List Edit SMS command in the right column to the device SIM number to achieve respective function as below: 1 2 3 4 5 6 Device status Device coordinate Location URL Check version Network setting Check parameter 7 APN setting 8 Server setting 9 SOS setting 10 GPS data upload time interval STATUS# WHERE# URL# VERSION# GPRSSET# PARAM# 1. APN, [apnname]# E.g: APN,internet# 2. APN, [apnname],[user],[pwd]# E.g: APN,internet,CLIENTE,AMENA# SERVER,mode,domain/IP,port,0# E.g. SERVER,1,www.
11 12 13 14 15 DISTANCE,D# D=0、50~10000 meter; Distance interval;default value:300, unit:meter; DEFENSE,A# Delayed defense A:1~60 minutes,set delayed defense, setting default value:10 minutes Vibration alarm 1. SENALM,ON# (default OFF) 2. SENALM,OFF# 1. MOVING,ON,R,M# R=100~1000; Displacement radius, Displacement alarm unit: meter setting M=0-2; Alert way (default OFF) 0:GPRS,1:SMS+GPRS; 2: GPRS+SMS+CALL E.g. MOVING,ON,200,2# 2.
8.Trouble shooting If you are having trouble with your device, try these troubleshooting procedures before contacting a service professional. Problems Poor signal Causes The signal waves unable to transmit when use the GPS tracker in the places that have poor signal reception, such as: tall building around or basement. Solutions Using the GPS tracker in the places that have good signal condition.
Warranty instructions and ser vice 1. The warranty is valid only when the warranty card is properly completed, and upon presentation of the proof of purchase consisting of original invoice indicating the date of purchase, model and serial No.of the product. We reserve the right to refuse warranty if this information has been removed or changed after the original purchase of the product from the dealer. 2.
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. FCC Warning This device complies with Part 15 of the FCC Rules.