User Manual Preface Thank you for purchasing the tracker. This manual shows how to operate the device smoothly and correctly. Make sure to read this manual carefully before using this product. Please note that specification and information are subject to changes without prior notice in this manual. Any change will be integrated in the latest release. The manufacturer assumes no responsibility for any errors or omissions in this document.
Contents 1. 2. 3. 4. 5. 6. Function Introduction......................................................................................................... 4 Applications ....................................................................................................................... 4 Hardware Description ........................................................................................................ 4 Accessories ................................................................................
7. 8. 6.27.6 Multi-area management ............................................................................... 17 6.27.7 Movement alarm .......................................................................................... 17 6.27.8 Over speed alarm ......................................................................................... 18 6.27.9 Fuel alarm .................................................................................................... 18 6.28 Alarms under Arm State ..........
1. Function Introduction 1.1. This tracker is a new product based on the WCDMA/GSM/GPRS network and GPS satellite positioning system, which set multiple functions of security, positioning, monitoring surveillance, emergency alarms and tracking in its entirety. It can track and monitor remote target by SMS or internet. 1.2. Features 1.2.1 Support both GPS & LBS (Location based service). 1.2.2 Support SMS/GPRS/Internet Network data transmission 1.2.
(5)Microphone jack (10)WCDMA/GSM/GPS LED (6)Micro USB (11)Back-up battery switch (12)Remote controller antenna(Optional for Model B only) 4. Accessories No. photoes NAME note 1 GPS Antenna 2 meters 2 WCDMA/GSM Antenna 2 meters 3 Microphone 1.
9 Fuel Sensor Option for both model A and B 5. Specifications Content DIM. Weight Network Band specifications 83*54*26mm 120g WCDMA/GSM/GPRS WCDMA (3G): 850MHz/1900MHz/2100(only for CE) GSM (2G): 850/900/1800/1900MHz GPS Sensitivity GPS Accuracy -159dBm 5m GPS Start time Cold status 45s Warm status 35s Hot status 1s Voltage Backup battery Storage Temp. Operation Temp. Humidity 12 V-24V DC Chargeable 3.7V 350mAh Polymer Li-Battery -40°C to +85°C -20°C to +65°C 5%--95% non-condensing 6.
Wiring diagram 6.1.5 Note: The orange wire can be connected to the original car horn; it can also be connected to the siren you buy with the tracker. (Siren is Option) 6.1.6 Knowing about the type of the door trigger is positive or negative trigger. Please connect the green wire to the door control circuit if it is positive, and connect blue wire if it is negative. 6.1.7 Please put SOS button at the place driver can touch. 6.1.8 Insert the external shock sensor plug into the sensor jack.
locked. The SMS format must be TXT format, and can’t recognize the PDU format. 6.3 Turn on the Tracker Device Connect the positive and negative wire, red and black ones, with 12V or 24V car power system, wait for 1 minute after connecting power to wait tracker works normal, and then turn on the backup battery switch. 6.
between two words. 6.7 Authorization 6.7.1 You must setup the authorized phone number before using SOS, geo-fence alarm, etc. Up to 5 numbers can be authorized. 6.7.2 Call the tracker for 10 times continuously and get its position, then it will save the cell phone number as the authorized number automatically. and reply “add master ok”. 6.7.
6.9 Auto track continuously 6.9.1 Track with limited times upon time interval Send SMS command “fix030s005n +password” to the tracker device, it will report the latitude & longitude at intervals of 30 seconds for 5 times. (s:second, m:minute, h:hour). This command set must be in 3 digits Arabic numbers and the maximum value is 255. e.g. fix030s005n123456 6.9.2 Track with unlimited times upon time interval Send SMS “fix030s030m***n+password” to the tracker.
6.11 GPS drift suppression 6.11.1 This function is deactivated by default, to activate this function, send SMS "suppress+password" to tracker, it will reply" suppress drift ok". The GPS data stop updating if vehicle is not driving (ACC is OFF) and latitude and longitude always keep same, and GPS data updates automatically when vehicle is moving. 6.11.2 Cancel: send "nosuppress+password" to tracker, it will reply" nosuppress ok ". 6.12 Exact street address 6.12.
6.15 Data logging 6.15.1 Auto logging:When the tracker device lost GSM signals or GPRS disconnected, tracker will log the tracking position and alerts automatically on the basis of the pre-set condition, when GSM signals get back, all the data will be auto-sent to the authorized numbers or web platform (server). 6.15.2 Logging upon times: Send SMS: “save030s005n+password” to the tracker unit, it will reply “save ok”, and will log the Latitude and longitude locations every 30 seconds for 5 times.
6.18.2 How it works: After accept balance command, tracker will remember the “mobile phone number”, carrier’s phone number and the code; 6.18.3 And then send the code to carrier’s phone number, and forward the message from carrier to mobile phone number.
less than 20KM/H”, and stop the car when the speed is less than 20KM/H. 6.20.3 Resume the Oil and Power System Send “resume+password" to tracker, it will reply "Resume engine succeed", it means the oil supply is resumed . 6.21 Calibration of fuel sensor 6.21.1 Due to the different height of fuel tank and fuel level sensor specifications, tracker need to set an appropriate zero value and full range value to detect the precise fuel percentage. 6.21.
6.23.2 Set up arm by remote controller (Option, for model B ONLY) button on the remote controller for 0.5 seconds, the car enters into armed Press state and the siren will beep one time, no SMS reply. 6.24 Disarm 6.24.1 Disarm by SMS Send SMS command "disarm + password" to the tracker device in the vehicle, It will reply “Tracker is deactivated” in both armed and disarmed state, and the SMS command will make the tracker device enter into disarmed state if the unit currently armed.
6.27 Alarms 6.27.1 Low battery alarm 6.27.1.1 Send SMS “lowbattery+password+space+on”, it will send SMS “low battery+latitude/longitude” to authorized numbers 2 times in total in 15 minutes interval when voltage of battery is going to be about 3.55V. 6.27.1.2 This function activates by default, send SMS “lowbattery+password+space+off” to deactivate. 6.27.2 Power off alarm 6.27.2.
SMS“stockade+password+space+latitude,longitude;latitude,longitude” to unit to set the restricted district. In case of breach, it will send SMS “stockade!+ latitude & longitude” to the authorized numbers. Remark: The first latitude & longitude is coordinate of the top left corner of the Geo-fence, while the second latitude & longitude is the coordinate of the bottom right corner, it will send alarm SMS at interval of 3 minutes once beyond the restricted district. 6.27.5.
6.27.7.2 Cancel: Send SMS “nomove+password” to deactivate the movement alarm. 6.27.8 Over speed alarm 6.27.8.1 Set up: Send SMS “speed+password+space+080” to the unit (suppose the speed is 80km/h), and it will reply “speed OK!”. When the target moves exceeding 80km/h, the unit will send SMS “speed+080!+ latitude & longitude” to the authorized numbers ,it will only send one SMS in 3 minutes in SMS mode when overspeed ; the siren will beep 1 time when overspeed 1 time. 6.27.8.
number in 3 minutes when the sensor is triggered in arm status. Within 3 minutes, the alarm siren sound for 5 seconds when the vibration is detected in the first time and second time. The alarm siren sound for 10 seconds when vibration again. If you disarm the tracker, the times will reset. Disarm to stop this alarm. 6.28.4 Built in Acceleration Sensor Alarm The tracker is built in three axis acceleration sensor, the tracker can detect it in arm state when the vehicle move, tilt or shock.
module work in low power consumption. ACC On or Calling, SMS and any triggered alarm can awake it. 6.29.1 This function is deactivated by default, send “sleep+password+space+on”, tracker will reply “sleep on ok”. When vehicle is not driving (ACC is OFF), WCDMA/GSM module fall asleep; GPS module shut off; and tracker works in low power consumption. Calling, SMS command and any triggered alarm can awake it. And less gprs traffic function will be activated by default in sleep mode.
6.32 Terminal (local) Time Setting 6.32.1 Send SMS command “time+space+zone+password+space+time” to the device, If succeed, it will reply “time OK” 6.32.2 For example: Send SMS “time zone123456 8”, 8 is Chinese time zone, If your country time zone is minus, send SMS “time zone123456 -8”. 6.33 Reset Hardware Send SMS “reset+password” to tracker device to reset the WCDMA/GSM module and GPS module of the tracker device, it will reply “reset ok”. 6.
6.35.2 GPRS User Name and password Setup 6.35.2.1 In most countries, the user name and password involving GPRS login are not compulsorily necessary, therefore, the entry can be skipped. As for those countries require user name and password, please configure as following: 6.35.2.2 Send SMS “up+password+space+user+space+password” If succeeded, the tracker will reply “user, password ok!” 6.35.2.
1 、 choose the right server to login in 2、Validate your IMEI is valid or not 3、Click "register". Pop-up a dialog box, register an account 6.37.2Login 4、Input the newly registered user ID and password, 6.37.
5、add terminal 6、add terminal 7.enter IMEI 8. name 9、choose location icon 10、save 11 .the newly registered device is offline in grey color 6.37.4 Configure your tracker to web platform to track it online step 1:set APN,refer to 6.35.1 Step 2:set GPRS user name and password,refer to 6.35.2 Step 3:set IP and port, please use the corresponding IP and port of the server you choose, refer to 6.35.3 Step 4:switch to GPRS mode,refer to 6.35.4 12.
1.37. If the tracker is always offline (grey color), make sure the SIM card subscribe the GPRS service, and have money to surf the Internet, you can use phone to test the sim card can surf the Internet or not please check the APN, user name, password, IP, port settings are correct, refer to 6.30. 2.37. IOS &Android mobile APP 6.38.6.1 Download and install the mobile APP software According to your phone type, download and install mobile app below the home page on web tracking platform 6.38.6.
5. Click here to operate the device 6.38.6.3 login in and use the mobile APP under SMS version 2.Use”mc” as the initial user ID,password is 8888, change the user name and password after entry 1.Choose SMS LOGIN 3.
4. Choose “add device” 5. Filling the device name 6. Choose the type 7. Filling the phone number of device 8. Filling the tracker’s password 9. Click “ok” 10. Click the icon, and display the list 11.
13.Click the buttons to send commands 14.Filling parameters manually and then click “send” 12.Click here to see more menu Remarks: “SMS login” version on Android phone can track the positions and show alarm on t he map; but "SMS login" version on IOS can only send commands due to the confined p olicy, it cannot track the positions and show alarm on the map. 7. Cautions Please comply with the instructions to extend the unit life: 1. Keep the unit dry. Any liquid, i.e.
8. Faults & the Solutions Faults Solution Fail to turn it on Please check if built-in battery is charged, and power wires connected well. No WCDMA / GSM signal No GPS Please check if GPS antenna connected well, and recommend GPS antenna be installed near the window glass, no metal parts can cover it to make sure better GPS signal reception. No reply to SMS command Password wrong or the format is wrong.
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.