User's Manual

ManualsBrandsShenzhen Chuangjiexing Electronics ManualsElectronicsRADIO TRANSMITTER

Ornament Motion Detector Transmitter

Warning: for indoor use only. The motion sensor detects motion to remote on lights for an

adjustable amount of time. A built-in photocell can be set to keep lights off when the lights aren’t

needed.. The unit has excellent sensitivity and wide 150 degree detection range.

Features include:

150 degree motion detection angle.

Adjustable on-time from 30min. to 4 hours.

Adjustable photocell.

Selectable ON, OFF, AUTO modes.

Battery Operated. 3 x AAA size Alkaline Battery(not included)

Installation

1. Select a location

Mount this ornament motion sensor on a X’mas tress. Choose a location where the motion

sensor has a clear view of the entire area where occupant motion may occur. To install this

motion transmitter near by an existing wall switch. Use only where the existing location

provides a clear view of the occupied area.

General Application Information: The detector is more sensitive to motion across the front

of the sensor than to motion towards the sensor. The detector senses heat in motion and

possible heat sources that change temperature quickly. Therefore, to avoid false triggering,

avoid placing the sensor where it will be aimed at air conditioners, heaters, and sources of

heat or cold.

Summary of content (4 pages)

PAGE 1
Ornament Motion Detector Transmitter Warning: for indoor use only. The motion sensor detects motion to remote on lights for an adjustable amount of time. A built-in photocell can be set to keep lights off when the lights aren’t needed.. The unit has excellent sensitivity and wide 150 degree detection range. Features include: 150 degree motion detection angle. Adjustable on-time from 30min. to 4 hours. Adjustable photocell. Selectable ON, OFF, AUTO modes. Battery Operated.
PAGE 2
. Installed To install, can bend X’mas tree branch on the 3 holes of its Stand. Or use the wire supplied, twist the X’mas branch to the Stand. Open the Ornament for adjusting or battery replacement. Press the button on top of the Ornament, then turn front cover out to open. To close, push front cover back.
PAGE 3
Adjust Time & Light Sensitivity The TIME and LIGHT knobs is at the right side of the battery compartment. TIME knob is on the top and LIGHT knob at bottom Time, The length of time that the lights stay on is adjustable from 30 minutes to 4 hours. Turning the knob marked with TIME to set the time by using the diagram as a guide. In the fully counter-clockwise position, the sensor turns off the lights 30 minutes after no movement detected.
PAGE 4
Back AUTO, Pressing again the button under the motion eye, the output will be controlled by the motion detector. The LED indicator will be flashed only when it detect any movement. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2.