User's Manual

BATTERY INFORMATION AND REPLACEMENT:
1. On the bottom of the remote use your finger to depress the tab to slide out the battery
holder.
2. Remove the used battery and insert a new CR2032 Lithium 3-volt battery with the “+”
polarity mark facing up.
3. Slide the battery holder back inside so that the tab sets in place.
4. Dispose of old battery properly.
WARNING:
Keep batteries away from children and pets.
Follow the battery manufacturer’s safety and usage instructions.
• Remove battery if product is to be left unused for a long time.
• Clean the battery contacts prior to battery installation.
• Do not dispose batteries in fire. Batteries may explode or leak.
Notice:
Functional Range may be adversely affected by one or more of the following factors:
Orientation of the transmitter or receiver, weather, radio frequency interference, low
transmitter battery and obstructions between the transmitter and receiver.
NOTE: In case of a power failure, the system will need to be reset.
ATTENTION: INSTRUCTIONS FOR PROPER USE
• FULLY EXTEND CORD BEFORE USING
• USE WITHIN THE ELECTRICAL RATING MARKED ON THE CORD SET
• RATED 125 VOLTS
• Unplug when not in use (grasp plug, not cord, to unplug from outlet)
• Inspect periodically
• Do not splice, repair or modify cord set
• Do not walk or drive on cord set
• Suitable for use with outdoor appliances - store indoors when not in use
• Suitable for damp location
• Do not use as permanent source of power
• When used outdoors, plug into a GFCI protected receptacle. Receptacle should be
mounted in an approved “weatherproof while in use” type outlet box. Install according
to all applicable local areas.
• Do not expose directly to water - rain tight
• Do not plug one extension cord into another
• Install the cord and unit above ground level at least 5 ft. (1.5m) with receptacles (outlets)
facing downward.
CAUTION
• Risk of Fire.
•
DO NOT PLUG IN MORE THAN THE RATED LOAD.
• This is a Radio Frequency (RF) Device. Therefore the range of the transmitter is affected
by obstructions, walls and other electronic devices.
WARNING:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
The user’s manual or instruction manual for an intentional or unintentional radiator shall caution
the user that changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FRONT
A5
5.8 in H x 8.3 in W
BACK
A5
5.8 in H x 8.3 in W
2 Outlet Outdoor Remote Control Instructions
with Countdown Timer Function
ITEM NO: 58373
Specifications
a. Receiver: 125VAC, 60Hz, 8A 1000W Tungsten with 2 Grounded Outlets and 6 in. (15.2 cm) 18AWG SJTW Power Cord.
b. Transmitter: 433MHz, remote range up to 80 ft. (24.3 m) using (1) CR2032 Lithium 3-volt battery (included).
Operation
a. ON/OFF Remote Control
Note: When the receiver is fully inserted into
a working outlet, its red indicator light
will come on showing power to the unit.
Press:
ON: Receiver is power ON continuously.
“ON” appears on the LCD display.
OFF: Receiver is power OFF instantly.
“OF” appears on the LCD display.
b. Remote Countdown
Press:
2Hr, 4Hr, 6Hr or 8Hr:
Receiver instant on and then off after
completing the selected countdown hours.
Notes:
1. Setting the countdown hours may be done
with the receivers ON.
2. The remaining countdown hours for the
receiver will be shown on the LCD display.
The countdown symbol at the top of “Hr”
flashes to indicate the countdown is in
progress. “ON” shows that power is on.
After the countdown is finished, the power
to the outlet goes off with “OF” displayed.
3. Pressing the remote ON or OFF button
cancels the current countdown operation
with power to the outlet remaining
continuously on or off.
c. Repeat function
This function repeats the last countdown
operation the same time everyday.
Press:
REPEAT ON: Do this during or after the countdown
operation.
“RPT” appears on the LCD display above “ON”.
Once the current countdown operation is finished
the countdown hours and RPT remain on the LCD
display.
Notes:
1. To cancel the repeat operation, press
REPEAT OFF. “RPT” will disappear. If in the
off status, the countdown operation hours
will also disappear.
2. Pressing the remote ON or OFF button cancels
the current day’s countdown operation with
power to the outlet remaining continuously on
or off. This will not interfere the next day’s repeat
operation.
3. Setting a new countdown operation cancels
the current day’s repeated countdown
operation. Power output will be ON or OFF as the
new operation. This will not interfere the next
day’s repeat operation.
Questions, call customer service toll-free at 1-877-398-7337 or visit us on the web at www.santasbestcraft.com Printed in China 2010
Antenna
Antenna
Antenna
with RT101T Remoter