User's Manual

TM313R

All weather Outdoor Digital Timer Instruction Manual

Initial setting

1. Plug the timer to the power outlet, the “C” will appear on the Digit LED.

2. Set Current Time: push the “TIME/MODE” button to set the current time hour.

The dot at the bottom right of the Digit LED will appear when the time at PM.

3. Set Timer ON time: push the “ON” button to quite and save above current time

setting. The “P” will appear on the Digit LED. Push the “ON” button to set the on

time.

4. Set Timer OFF time: push the “OFF” button to quite and save above on time

setting. The “E” will appear on the Digit LED. Push the “OFF” button to set the

off time.

5. Quite and save initial setting: push the “TIME/MODE” button to quite and save

the initial setting. The Digit LED will display the current time and start the

normal operating

6. The initial setting must follow the above procedure, otherwise the unit will not

start the normal operating to waiting for you to finish it.

Review the On/Off setting

1. Review On time: push “ON” button once, the Digit LED will display “P” first

and then the On time.

2. Review Off time: push “OFF” button once, the Digit LED will display “E” first

and then the Off time.

Change the current setting

1. Change the current time: push and hold the “TIME/MODE” button for 2 seconds,

the current time display will flash. Push the “TIME/MODE” button to change the

PAGE 1
TM313R All weather Outdoor Digital Timer Instruction Manual Initial setting 1. 2. 3. 4. 5. 6. Plug the timer to the power outlet, the “C” will appear on the Digit LED. Set Current Time: push the “TIME/MODE” button to set the current time hour. The dot at the bottom right of the Digit LED will appear when the time at PM. Set Timer ON time: push the “ON” button to quite and save above current time setting. The “P” will appear on the Digit LED. Push the “ON” button to set the on time.
PAGE 2
. 3. current time. Change the On time setting: push and hold the “ON” button for 2 seconds, the On time will display and flash. Push the “ON” button to change the On time setting. Change the Off time setting: push and hold the “OFF” button for 2 seconds, the Off time will display and flash. Push the “OFF” button to change the Off time setting. Manual Override 1. 2. 3. Continuously On: push the “TIME/MODE” button till the Digit LED display “O”.
PAGE 3
Specifications: 125VAC 60Hz 15A 1,800Watts Resistive Load 8A 1,000W Tungsten Load FCC warning Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. This device complies with Part 15 of the FCC Rules.