User's Manual

RS101

RF Remotely Operated Indoor Switch Instruction Manual

Instructions

Insert the Remote Base’s 2-prong polarized plug into a polarized outlet. Plug

appliance into located on bottom of Remote Base. Using the Wireless Remote Control.

Press ON button to activate device. Red indicator light is lit when the indoor

receiver/switch is on.

Battery Replacement

Use 23A 12volt battery (L1028). To replace, screw off back cover on back of Wireless

Remote Control. Do not dispose of batteries in fire. Batteries may explode or leak

Caution

DO NOT splice , repair or modify. Unplug when not in use. Fully insert plug. DO

NOT use damaged remote sets. Inspect periodically. Use within the electrical rating

marked on the remote set. DO NOT plug more than a total 600 watts in this remote set.

If watts are not marked on appliance, multiply ampere rating(on nameplate) by 125 to

determine equivalent watts. Add determined watts for each plugged-in appliance or

lamp (sum of watts on bulbs) to find total watts being used. Operating temperature

range 0C (32F) to 45C (113F).

Specifications:

125VAC 60Hz

5A 600Watts Resistive Load

FCC warning

Warning: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received including interference that may

cause undesired operation.

PAGE 1
RS101 RF Remotely Operated Indoor Switch Instruction Manual Instructions Insert the Remote Base’s 2-prong polarized plug into a polarized outlet. Plug appliance into located on bottom of Remote Base. Using the Wireless Remote Control. Press ON button to activate device. Red indicator light is lit when the indoor receiver/switch is on. Battery Replacement Use 23A 12volt battery (L1028). To replace, screw off back cover on back of Wireless Remote Control. Do not dispose of batteries in fire.
PAGE 2
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.