K-10 Walkie Talkie User Guide US
Product Features CAUTION Read this operating instruction carefully before using your two way radio, including the part on Product Safety and Important Notice.
Backlit LCD Display Features • 22 Channels 4 3 2 5 Seven shared with FRS/GMRS, 9 seven FRS only, 1 eight GMRS only. 14 6 • 10 Channel NOAA All 7 Hazards Radio • Weather Alert • 121 Privacy Codes (38 CTCSS codes/83 DCS codes) 8 • Hands-Free Operation 13 (VOX) 12 • Scan 11 10 Channels, privacy codes 1. Battery Level Indicator • Backl it LCD Display 2. Roger Beep Icon • Cal l Alert 3. VOX Icon Ten selectable tones 4. Weather Icon • Button Lock 5. Lock Icon • Speaker/Microphone/Jack 6.
Battery Low Battery Low To Adjust Volume When battery power is low,the final bar in the Battery Low icon will blink and an audible tone will sound twice before the radio shuts off. Your batteries should be replaced or recharged, if using rechargeable batteries. The radio will display flashing battery icon whi le charging. Rotate Volumen Knob until you reach a comfortable listening level.Rotate Volume Knob clockwise to increase the volume or counterclockwise to decrease the volume.
Privacy Codes Set DCS Privacy Codes Your radio incorporates two advanced coded squelch systems that can help to reduce interference from other users on any given channel. CTCSS (Continuous Tone Coded Squelch System)provides 38 privacy codes and DCS (Digital ly Coded Squelch)provides 83 privacy codes. This provides a total of 121 Privacy Codes. Either system can be used on al l channels, but both systems cannot be used on the same channel at the same time.
The current VOX sensitivity level is displayed with letters“L” and a Number 1 through 3,with Number 3 being the most sensitive level and Number 1 being the least sensitive level. To turn VOX mode on or off: 1. Press the Menu/Power button unti l the VOX icon flashes on the display. The current On or Off setting is displayed. 2. Press the Up or Down button to turn VOX On or Off. 3.
Scan Channels The Scan icon will continue to be displayed when scan is on. Your radio will continue to scan all channels and stop if an incoming transmission is detected. Your radio will remain on that channel for 10 seconds. During scanning (while receiving an incoming transmission), you can choose from the following: a. Press and hold the Talk button to communicate on that channel. Your radio will remain on that channel and return to Standby mode. b.
IMPORTANT NOTICE: FCC LICENSE REQUIRED Governments keep the radios in classification, most of the classified walkie-talkie need to get local government License, and operation is allowed. The detailed classification and the use of your two radios, please contact the local government radio management departments. For the following specified classification:the USA FRS, Australian CB, the individual license is not required.