User's Manual

Card-lock User Manual Model
：
CD229
Cabinet lock operation statement
1.
Initialize and change door opening mode
Press and hold the initial button when you hear a "di" sound and release your hand for single
card mode, press again to hear a "di di" sound and release your hand for dual card mode,
press again to hear a "di di di" sound and release your hand It is a one-time open door mode.
These three modes switch cyclically, set the corresponding mode as needed.
2.
Method of Configurating Management Card
If the initialization is successful, swipe the management card twice, then the management
card is set successfully.You can also set up dual management cards, you should swipe the
two management cards once in a row
3.
Single card configuration method
●Swipe the management card once and the lock makes a sound
●Swipe the user card once during the sound, the user card is set successfully
If the user card is not set successfully, you need to re-operate
4.
Dual card configuration method
●Swipe the management card once and the lock makes a sound
●Swipe the guest card once during the sound, the guest card setting is successful
●Swipe the management card again, the lock makes a sound
●Swipe the waiter card once during the sound (the waiter card can be multiple)
In the dual card mode, the waiter card and the guest card can be used together to unlock,
and the card is swiped in no particular order
5.
Self-service storage (one-time open door mode) configuration method
●Assuming that any card A swipes once to close the lock, you must use the card A to open the
door when opening the door, and the lock is emptied after unlock
●Assuming that any card B swipes once to close the lock, you must use the card B to open the
door when opening the door, and the lock is emptied after unlock
After the cycle of one lock and one open, the lock is cleared and can be used by the next
user
6.
Delete card
Swipe the management card six times in a row to clear all cards. Please operate with caution.
The management card itself will not be cleared. To clear the management card, initialize the
lock.
Be careful：
●When installing this lock, be sure to install the battery and test before use, otherwise the
electronic lock will not work out of the scope of maintenance.
●In addition, please take good care of the management card you have set up to protect the
user’s private storage.
●The lock will automatically open when the battery life reaches the limit. Please replace the
battery before automatically opening to ensure safe storage.