User's Manual

which can be determined by turning the equipment off and on, the user is
equipment generates, uses and can radiate radio frequency energy and,
candle
4
2017.1.11
BTL305-SYZN-0011
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device must not be co-located or operating in conjunction with any
other antenna or transmitter.This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However,there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC's RF radiation exposure limits for general population/
uncontrolled exposure, this device must be installed to provide a separation
distance of at least 20cm from all persons.
WARNING: Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
This device must not be collocated or operating in conjunction with any
other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject