INSTALLATION NOTES Ensure that the rechargeable Ni-MG battery is installed inside the handset battery compartment. Make sure the polarity is correct. v Set the RINGER ON/OFF switch on the handset to the ON position for normal use. + Its strongly recommended that the Rechargeable battery be fully charged for at least 12 hours before initial use INSTALLATION CAUTION: USE ONLY THE Ni-MG BATTERY TYPE INCLUDED WITH THIS UNIT, USE OF OTHER BATTERY TYPES MAY CAUSE INJURIES OR DAMAGE.
Wall Mounting You may choose to install the TC960 base unit onto a wall. Wall Mounting (Standard Wall Jack--not included; 1. Connect the short telephone line cord to the telephone line jack on the rear of the base unit. Insert the other end through the hole of the wall mount bracket. Insert the hooks of the wall mount bracket into the matching slots at the bottom of the base unit then slide them upwards until they lock into place.
BASE UNIT Figure 6 HEADSET CONNECTION One of the special features of your phone is that your handset (not included) can utilize a headset for hands-free communication. Insert the small plug at the end of your headset cord to the headset jack at the side of the handset as show in figure 7. Follow the procedures discussed in “Placing a Call” and “Receiving a Call” how to place and receive a call. NOTE: The headset jack of your TCY60 is compatible with 2.5 mm headset plug only.
* The IN USE/ LOW BAT LED indicator wil flash rapidly (to indicate that it is auto-scanning}. After it has found a clear channel, the IN USE/ LOW BAT LED indicator will light solid. You can then start conversation with the calling party. Channel Selection (40 Channels) Channel Scan (Auto-Scan + When you initiate or receive a call, the TC960 auto-scans for the best channel available.
Dialing a Number from Memory I. Pick up the handset and press the TALK button. The handset IN USE/ LOW BAT LED indicator flashes while auto scanning for the best channel available. A dial tone will be heard when the IN USE/ LOW BAT LED indicator lights solid. 2. Press the MEMO button. 3. Press the memory location (0-9) on the keypad for the number you have stored. The stored number will be dialed automatically.
Out of Range Detection The TC960 is equipped with an Que-of: Range detection system. If you have the handset too far away from the base unit during a call, the handset may lose its link with the base unit. When this happens, the handset emits a beeping sound every second to warn you that the background noise level is too high for proper communication between the handset and the base unit.
Charging I 15 Make sure the AC adapter and telephone line cord is connected to the TCI60. Place the handset on the base cradle. The IN USE/CHARGE LED indicator will steadily light up on the base unit. Leave the handset charging on the base for 12 hours continuously to get a fully charge. The TC960 is now ready for regular use.
TROUBLESHOOTING SYMPTOM SOLUTION Ne dial tone Check to see i the handset battery pack is connected inside the handset battery compartment. Make sure that the adapter plug is connected to the base unit. Check for the telephone line cord connections. Ensure that both connectors are plugged securely on the jacks. Ensure that no other telephone is sharing the same line as the TC966 when off-hook. Test the phone at a different telephone wall jack and listen for a dial tone.
SYMPTOM SOLUTION The unit locks up and becomes inoperable in the unlikely event that the unit locks up and becomes inoperable, you can reset the system by momentarily disconnecting and reconnecting the handset battery pack.