TC USE THE UNIT AS A WALL PHONE When using this unit as a wall phone, remove the cradle tab by sliding it upward. Rotate and flip the cradle tab around. Reinsert it with the lip up by sliding the cradle tak downward sturdily it clicks in pace. See Figures 1A and 1B below. Remove the mounting bracket on the back of the base unit, rotate and reinsert it. See figures 1C and 10D below.
TO PLACE A CALL After the battery has been fully charged, lift the: antenna on the base unit for best reception. Press the TALK button and listen for a dial tone; the IN-HOUSEBOAT. LOW indicator will blink rapidly while scanning for a clear channel. Press the key bunions {0-9) to dial ‘the specified number you wish io teal esl u 238 mH 222 a2 260 ee) 8% Le Busy Signal Press the FLASH button to hang up and get a new dial tong.
TO RECEIVE A CALL To receive a call if the phone is or the base, simply pick up the phone off the has when the phone rings and start the conversation has, simply press the TALK button on {the handles and start the conversation. RINGER ON/OFF SWITCH: MN/OFF 5 Ba the ON position to turn the rings.
A | REDIAL BUTTON LL are not sure of your service, pl contact your telephone compare FLASH BUTTON 25g Rags this button to momenta. up.
STORING/RECALLING NUMBERS INT THE 10 MEMORIES TEI un R20 HO Make sure the pane is not online (the IN HOUSEBOAT LOW and IN USE/CHARGE indicators will be off}. Press the MEMO bunion on the handset, a beep will be heard. Enter the telephone number you want to store {up fo 16 digits) on the handset. if you want a pause of 2 seconds, press the Redial/Pause button {this will count as one digit). TES IT CO 2eg 22d \HOO HOC © pep mar Bp Press the MEMO button again and Repeat steps 1 through 3 to store then press th
SYMPTOM SOLUTION No dial tone. Make sure the telephone line cord is connected properly to the modular wall jack. if a power failure occurred or the base unit was unplugged, return the handset to the base for 3 to 5 seconds fo reset the system, Does not ring Check the RINGER ON/OFF switch on the handset. Setting this switch to the OFF position disengages the ringer fo conserve the battery power. Switch to ON position to enable the ringer.
NJ Care and Maintenance 1. Clean your phone with a damp {never wet) cloth, Solvent or detergent should never be used. 2. Avoid operating your unit under direct sunlight or in hot, humid or dusty places. 3. Keep your unit away from heating appliances. Trademark Write-Westinghouse used under license Printed in Chung 2001 White-Consolidated Industries, Ine.