How-To Guide

Table Of Contents

HOW TO USE:

1. Take the USB receiver out of keyboard, snap it into the USB port.

2. Put 2pcs of AA batteries into keyboard and swtich the keyboard power

on, once the Num Lock indictor shows red, you can use them freely.

3. Put 1pc of AA battery into mouse, then switch the mouse power on.

Where is the USB receiver located?

IIf the keyboard can’t connect to device.

The keyboard is plug and play. If it is not working, pls try below steps.

Insert 2pcs of AA battery into keyboard, then switch the power on,once Power LED

is on, pls plug the receiver into USB port immediately, then hold ESC+K at the same

time, once the NUM LED flashes, the paring is completed.

If the mouse can’t connect to device.

Pls unplug the plug the USB receiver, then switch the mouse power on.

IIf it is still not working, pls re-peat the below steps.

The USB receiver is located next to

the keyboard battery compartment.

PAGE 1
HOW TOUSE: 1 .Tak et heUSBr ec ei v eroutofk e y boar d,s napi ti nt ot heUSBpor t . 2.Put2pc sofAAbat t er i esi nt ok e y boar dands wt i c ht hek e y boar dpower on,onc et heNum Loc ki ndi c t ors howsr ed,y ouc anus et hem f r eel y . 3.Put1 pcofAAbat t er yi nt omous e ,t hens wi t c ht hemous epoweron. Wher ei st heUSBr ec ei v erl oc at ed? TheUSBr ec ei v eri sl oc at edne x tt o t hek e y boar dbat t er yc ompar t ment . I ft hek e y boar dc an’ tc onnec tt ode v i c e .
PAGE 2
§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.