Installation Instructions

ManualsBrandsShenzhen Baida Moxing ManualsElectronicsRC Radio Transmitters

CONTENT

Installing the Tramsmitter Battery

Power the Transmitter On and Off

Switching Protocol

Binding the Receiver

Battery Alarm & Charge the Battery

HID Joystick

Student Radio Mode

OpenTX Companion

FAQ

The front side of the radio.

The back side of the radio.

Installing the Transmitter Battery

1. Remove battery cover from the back of the transmitter.

2. Connect the included 2 piece 1S batteries to the power cable, and insert

Summary of content (8 pages)

PAGE 1
CONTENT Installing the Tramsmitter Battery Power the Transmitter On and Off Switching Protocol Binding the Receiver Battery Alarm & Charge the Battery HID Joystick Student Radio Mode OpenTX Companion FAQ The front side of the radio. The back side of the radio. Installing the Transmitter Battery 1. Remove battery cover from the back of the transmitter. 2.
PAGE 2
the connector to the transmitter. 3. Install the battery cover. Power the Transmitter On and Off 1.Press the power button until the transmitter shake twice, then release the power button. The LED will be green first, and turn to blue finally. 2.Press the power button until the transmitter shake once, then it will turn off. LED Status Red Solid Green Solid Blue Flash Slow Reason Solution The throttle stick or switches are not in the lowest Lower throttle and sw to the lowest positio to blue then.
PAGE 3
1. Make sure the transmitter is powered on. 2. Press the BIND button from the back of the transmitter. The transmitter will enter the binding mode and last about 10 seconds, indicated by blue and red LED flash alternately. 3. Check the receiver if binding successfully. If not, redo the process above. Battery Alarm & Charge the Battery The blue LED flashes slowly when the battery reaches the low voltage limit. Plug in USB for charging.
PAGE 4
1. Press and hold the SETUP button from the back of the transmitter. 2. Press the power button on the transmitter. And then release both buttons. The LED ring will not power on . 3. Connect the transmitter to the computer via a USB cable. 4. Open the OpenTX Companion software. 5. Set the radio type to Lite Radio in the settings page. As show below. Do not forget to press the OK button at the end of this tab. 6. Press the second button on the left column to read models and settings from the radio.
PAGE 5
The frequent usage of the OpenTX Companion is trim the gimbal central value. For example, You find the center value of the gimbal on the roll axis is 1525 in the Betaflight Configuration. The central value of the gimbal in the range of 1500+-5 is normal. 1. Click the Edit Radio Settings in the dialog above. In the pop new dialog, choose the Calibration tab. As show below. 2. Calculate the calibrated Mid Value according to the equation below.
PAGE 6
The table above is just for the Mode 1 ( right hand throttle). So if you have a Mode 2 radio transmitter (left hand throttle), if you want to calibrate the pitch value, you must change the Mid Value in Throttle row. 4. Now back to the Betaflight Configuration, confirm if the gimbal calibra tion works.
PAGE 7
Q: What is the expected range from the LiteRadio V2 transmitter? A: The average output power is about 80mW on the transmitter. Also the valid range of the radio transmitter depends on the receiver. This is our testing use this LiteRadio V2 transmitter.
PAGE 8
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.