Installation Instructions

FCC Caution:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference recei

-ved, including interference that may cause undesired operation.Any changes or modifications not expre

-ssly approved by the party responsible for compliance could void the user's authority to operate the equi

-pment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, p

-ursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against h

-armful interference in a residential installation. This equipment generates, uses and can radiate radio freq-

uency energy and, if not installed and used in accordance with the instructions, may cause harmful interfe

-rence to radio communications. However, there is no guarantee that interference will not occur in a parti

-cular installation.

If this equipment does cause harmful interference to radio or television reception,which can be determine

-d by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and o-

perated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.

Smart Thermostat