Instruction Manual

ManualsBrandsShenzhen B&W Electronics Development ManualsComputers & AccessoriesWireless keyboard

单色双面印刷

86*108mm

Install the Batteries

Other Advantages

Hotkeys of Keypad

: Open the calculator

Esc: Same as Esc key function (when the calculator is open, it indicates reset)

1. Power Saving design: when there is

no action for the keypad about 10mins,

it will enter dormant state, just press

any key can active it.

1.Switch to ON position from the

back of the keypad.

2. Long press key with 3 seconds

until the LED1 shows red flicker.

3. Find Setting in your device,

and turn on Bluetooth function in

your device.

4. Find and select "Bluetooth Keyboard"

from the list and click to pair.

2. Two AAA alkaline batteries: so

the whole system voltage is 3V.

Step 1: Remove the battery cover back by squeezing it from the

keypad to release it.

Step 2: Put the batteries inside as shown.

Step 3: Recover it.

This wireless keypad uses two AAA alkaline batteries

long press

Wireless Mini Numeric Keypad

Model:BT022

Instruction Manual

CAUTION: To use this device properly,please read the

instruction manual carefully before the usage.

Backspace

This keypad has two red LED indicator lights.

Press Number 1: END

Press Number 2: DOWN

Press Number 3: PAGE DOWN

Press Number 4: LEFT

Press Number 6: RIGHT

Press Number 7: HOME

Press Number 8: UP

Press Number 9: PAGE UP

Press Number 0: INSERT

Press “ . ”:DEL

LED1 LED2

1.Turn the switch to ON position, the LED1 light will go

on and then go out after 3 seconds, then the

keypad enters the Power Saving mode.

2.Long press the key for 2-3 seconds, the LED1 will

flick red, it indicates the keypad enters the pairing state.

3.When the battery voltage is lower than 2.1V, the LED1 flicks red,

please replace the batteries.

4.When the NumLock function is ON, the LED2 will be bright, then you can input

numbers by pressing the number keys.

5. When the NumLock function is OFF, the LED2 will go out, and all numeric keys will

be not effective,and the following is how the functions keys work:

Summary of content (2 pages)

PAGE 1
Instruction Manual This keypad has two red LED indicator lights. 1.Turn the switch to ON position, the LED1 light will go on and then go out after 3 seconds, then the keypad enters the Power Saving mode. 2.Long press the key for 2-3 seconds, the LED1 will LED1 LED2 Wireless Mini Numeric Keypad Model:BT022 flick red, it indicates the keypad enters the pairing state. 3.When the battery voltage is lower than 2.1V, the LED1 flicks red, please replace the batteries. Backspace 4.
PAGE 2
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.