User's Manual

ManualsBrandsShenzhen Aodelan Technology ManualsElectronicsWireless Remote Shutter Release Transmitter

PEBBLE Wireless Shutter Remote



Thank you for purchasing an Aodelan product:

Note: Before using the Aodelan PEBBLE Wireless Shutter Remote, please read this

instruction manual carefully.



PEBBLE Wireless Shutter Remote consists of a transmitter and receiver. The transmitter can

control the receiver wirelessly to perform autofocus, single shot, delayed release and continuous

release. The receiver can also be used as a wired shutter remote to do autofocus, single shot, and

continuous release.



Warnings:

1. Remove the batteries if the remote will not be used for an extended period.

2. Do not expose the product to high temperature, or use the product in hot place,

such as a closed car in direct sunlight.

3. Please keep the product dry. Do not touch the product with wet hands, immerse it

into water, nor expose it to rain, or it may get damaged.

4. Do not use the remote at flammable environments. Violation of this warning may

cause explosion or fire hazard.

5. When using the product, please keep it away from other 2.4GHz devices to avoid

interference（e.g. WIFI）.



FCC Interference Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This device and its antenna must not be co-located or

operating in conjunction with any other antenna or transmitter.

FCC Compliance Statement

NOTE:

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

Summary of content (6 pages)

PAGE 1
PEBBLE Wireless Shutter Remote Thank you for purchasing an Aodelan product: Note: Before using the Aodelan PEBBLE Wireless Shutter Remote, please read this instruction manual carefully. PEBBLE Wireless Shutter Remote consists of a transmitter and receiver. The transmitter can control the receiver wirelessly to perform autofocus, single shot, delayed release and continuous release. The receiver can also be used as a wired shutter remote to do autofocus, single shot, and continuous release. Warnings: 1.
PAGE 2
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
PAGE 3
1. Power Button 2. Shutter Button 3. LED Indicator 4. Remote Release Terminal 5. Locking Ring 6. Cold Shoe/Tripod Lug 7. Battery Compartment Turn on/off 1. Install batteries for the release remote: 1 pc of CR2032 battery for the transmitter, and 2 pcs of AAA type alkaline or NI-MH batteries for the receiver. Make sure the batteries are located according to the “ +/-“poles of the compartments. 2.
PAGE 4
1. 2. Install batteries for the transmitter and receiver. Press and hold the receiver’s power button and shutter button for 2s until the indicator on receiver continuously blinks (5s). 3. Press the shutter button on transmitter one time to reset the code. When the code is successfully set, the indicator on receiver will shortly stop blinking. After that, it will go on blinking quickly, indicating that the receiver remains in code setting state.
PAGE 5
shutter button on transmitter. Specification Frequency 2.4GHz Power Supply 1 pc of CR2032battery（Transmitter）; 2 pcs of AAA alkaline/ NI-MH batteries（Receiver） Transmission Distance 80m+ （Open space without interference） Dimension L 67 * W 36 * H 13 mm（Transmitter）; L 90 * W 41 * H 32 mm（Receiver） Weight 13g（Transmitter）; 37g（Receiver）—Excluding batteries Please note: Product specification and external design are subject to change without further notice. * On compatible cameras.
PAGE 6
The Warranty Does Not Apply to: 1. Failure to provide invoice, the Three Guarantee certificate, and other proof to prove that the product is within warranty time of the Three Guarantee service. 2. The main unit, invoice or the content of the Three Guarantees certificate is inconsistent with the physical goods or has been altered. 3. The main unit and accessories had been subject to abnormal usage or misuse.