Ultra-Portable Bluetooth Speaker Quick Start Guide Designed and Engineered By Please visit TheOontZ.
Table of Contents In the Package Play Controls LED Lights and Connectors Charging the Battery Turning On and Off Pairing & Connecting Pairing & Connecting -- From Your Mobile Device Pairing & Connecting -- From Your Apple Mac or Windows Computer Playing From Your Laptop, Computer and Non-Bluetooth Devices Using the 3.
In the Package USB Micro Charging Cable 3.
Play Controls Power Button Bluetooth Button (Dual Function) Button (Dual Function) Button (Dual Function) Volume Down Press and Release to decrease volume one level; continue to press and release until volume lowers to desired level Volume Up Press and Release to increase volume one level; continue to press and release until volume raises to desired level Note: Holding the button down will result in track back Track Back Press and Hold Down for 2 Seconds Note: Holding the button down will result in
LED Lights and Connectors Built-in Mic for Speakerphone Bluetooth LED Light (Blue) (LED is only visible when speaker is turned on) Charging LED Light (Red) (LED visible when connected to a charging source and when battery charge is low) Rubber Flap (lifts up from top) AUX IN Jack (located under rubber flap) Note: Use the smaller end of the Micro USB Charging Cable to pry open the rubber flap, if necessary.
Charging the Battery The lithium ion rechargeable battery comes with a partial charge and is ready to play. For maximum playtime, fully charge the battery. You can play while charging.
Charging the Battery (continued) Music Play Time Up to 7 hours on a full charge, with volume at 60%. Louder volumes will reduce the battery play time Play while charging You can play the OontZ Angle 3 Plus while it is charging Power Saving Feature - When playing from battery power the OontZ Angle 3 Plus will turn off after 15 minutes of not playing audio to conserve the battery charge - When plugged into a charging source the OontZ Angle 3 Plus will remain on until you turn the power off.
Turning On and Off Bluetooth LED Light (Blue) (LED is only visible when speaker is turned on) Power Button Turn ON Press and Release the Power Button - Blue light will turn on Flashing Blue speaker is in pairing mode and ready to connect Solid Blue speaker is connected to a source device and ready to play Turn OFF Press and Hold Down the Power Button for 2 Seconds Blue light will turn off Page 6
Pairing & Connecting - Make sure your OontZ Angle 3 Plus battery has a sufficient charge - Your source device needs to be within 30 unobstructed feet of the OontZ Angle 3 Plus Turn ON your OontZ Angle 3 Plus The Blue light will turn on Flashing Blue the OontZ Angle 3 Plus is ready to pair and connect Solid Blue the OontZ Angle 3 Plus has automatically reconnected to the last source device the speaker was connected to and is ready to play.
Pairing & Connecting -- From Your Mobile Device To pair and connect from an iPhone, iPad, or iPod: To pair and connect from a Smartphone or Tablet: - Go to Settings > Bluetooth, check Bluetooth is on - Select ‘OontZ Angle 3 Plus’ when it appears under DEVICES - The speaker will connect in a few seconds - The Bluetooth LED Light (Blue) will be solid blue - You can now play your audio wirelessly to your OontZ Angle 3 Plus - Go to Settings > Bluetooth, check Bluetooth is on - Scan or Search and select ‘Oont
Playing From Your Laptop, Computer and Non-Bluetooth Devices Using the 3.5mm Audio Cable - Make sure your OontZ Angle 3 Plus battery has a sufficient charge Step 1: Pull down the rubber flap from the top to access the Micro USB Charging Connector Step 2: Plug one end of the included 3.5mm audio cable into the AUX IN Jack as shown Step 3: Plug the other end of the 3.
IPX6 Water Resistant No more worries about the rain or getting splashed Listen to music in the shower Perfect for taking to the beach or by the pool Gentle Water Spray or Splash is okay DO NOT allow speaker to sit in water DO NOT allow speaker to submerge fully or partially in water IPX6 rating - The OontZ Angle 3 Plus can resist gentle water spray & splash but cannot be partially or fully submerged or left in a wet environment for an extended period of time, any of which could cause unrepairable damage
Wireless Hands Free Personal Speakerphone To answer an Incoming Call / To End a Call Press and Release the Bluetooth Button Bluetooth Button (Dual Function) To Reject an Incoming Call Press and Hold Down the Bluetooth Button for 3 Seconds The Wireless Hands Free Personal Speakerphone feature works over Bluetooth with Smartphones and iPhones for cell phone calls only Please keep the speaker close in front of you so you may be heard clearly by the listener You can use your Smartphone or iPhone to switch bet
Troubleshooting & Customer Support For assistance with questions or any issue with your OontZ Angle 3 Plus that is not answered in the troubleshooting tips below, please contact us by visiting: TheOontZ.com/support and fill out our customer service form OontZ Angle 3 Plus will not turn on • The battery may have become fully drained. Charge the OontZ Angle 3 Plus using a USB wall charger from a Smartphone/iPhone or tablet for at least 15 minutes, then press the power button to turn the speaker on.
Cannot pair or connect to the OontZ Angle 3 Plus (continued) For iPhone, iPad, iPod • Turn off the OontZ Angle 3 Plus speaker, go to the Bluetooth device list on your iPhone, iPad or iPod and check if the OontZ Angle 3 Plus is listed. If it listed press the icon next to the OontZ Angle 3 Plus and then forget this device, twice.
No audio playing from the OontZ Angle 3 Plus when connected over Bluetooth • Reset the OontZ Angle 3 Plus, follow the reset instructions on page 15. • Remove the OontZ Angle 3 Plus from the Bluetooth device list on your source device, restart your source device, and then re-pair and connect to the speaker. • Make sure the volume is up on your OontZ Angle 3 Plus and your source device. • Make sure your Bluetooth device is playing audio, and is not paused and volume is up.
Resetting Your OontZ Angle 3 Plus To reset the OontZ Angle 3 Plus insert either a toothpick or straightened paper clip into the AUX IN jack until it makes contact with the micro switch. Gently push and release the switch and the speaker will reset.
Safety and Precautions 1. Follow all instructions – All operating and use instructions should be followed 2. Do not use this speaker near water while plugged in for charging, due to risk of electric shock 3. Do not charge when wet 4. Protect the Micro USB charging cable from pinched particularly at the connectors 5.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
