(US/EN) User's Instructions (Page 1-15) (DE) Benutzeranleltung (Page 16-30) (FR) Mode D'emplol (Page 31-45) (ES) Ins盯cclones del usuarlo (Page 4氐60) (IT) Manuale utente (Page 61-75) (US/EN) User's Instructions T-888 Walka Ta值las
& CAUTION Read this operating instruction carefully before using your下888 two way radio, including the part on Product Safety and RF Energy Exposure Compliance TX/RX Icon Product Inspection Before in巾al use, please check if the product inside the box is in good cond巾on or not. If there are any signs of damage or missing parts, please feel free to contact the carrier or seller.
Talk Button Belt Clip Kids can clip the units to their pocket or elsewhere while Press and hold this button to talk and let go to listen they are on the go. Up and Down Key Call Tone Button To select channels, set CTCSS code, adjust volume By pressing button J, you can Inform other radio users level, listening volume and other function in your group that you want to talk or have finished talking. When button J is pressed, a tone would be Charging Port with Silicone Dust Cover transmitted.
RECEIVER 兰巨兰;二二 言i Spurious response inhibition Audio output power Audio distortion tance I >70dB >300mW 幼% How to attach the strap(Not Included in Orders) to the belt clip If you need to thread the strap.
Adjusting volume level Use the up/down key to increase or decrease the volume. And you can always find the volume level indicator in the lowe『right comer of the screen namely, you cannot switch to another channel under this status. To unlock the channel lock function, press MENU button again for about 2 seconds until the icon disappears on the screen Receiving The radio is ready to receive signals when ii is tuned to the channel that has the same frequency and CTCSS code as the one that is lransmilling.
Using up/down key to select the code, Press "TALK" button lo confirm selected code and complele setting. Note: T-888 can only work together when the units are luned to the same channel and have the same CTCSS code on that channel VOX for Hands-free 0 :�雷盓需霖it��飞)!1� 1�,界aa;; ·.J, Tap MENU button three times, then 白 ·••Ir,� 1 (;, h .... 乙 rm ct m04 豆了 11m n ual bloill oe u Kbrm TthyoedelU IIw ow CaH rm MEN TAL to 气言 芒已古巴 "VOX" and VOX sensitivity level (OF,01 ,02,03) will be displayed on the screen.
Battery Level Indicator Displayed in the lower right corner of the screen, convenient to know how much battery power is remained. When the indicator on the screen blinks, it means that the batteries need to be charged Battery Charging To protect the life of the rechargeable battery, we recommend you always using an high quality AC charger for charging. Plug the cable into the jack (on the top of the device) to charge the batteries Do not use the device in an environment that may cause fire or explosion, e.
Product Features Serial number CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16 PMR Frequency 44600625 44601875 44603125 44604375 44605625 44606875 44608125 44609375 44610625 44611875 44613125 44614375 446.15625 446.16875 44618125 44619375 Power 05W 05W 05W 05W 05W O.
RF ENERGY EXPOSURE AND PRODUCT SAFETY GUIDE FOR PORTABLE TWO-WAY RADIOS r (I�言言兰兰言卢 ta/:// ca Local Government Regulations When two-way radios are used as a consequence of employment, the Local Government Regulations requires users to be fully aware of and able to control their exposure to meet occupational requirements Exposure awareness can be fac山tated by the use of a product label directing users to specific user awareness information. Your two-way radio has a RF Exposure Product Label.
NOTE •(If applicable)This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause ham而I interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver.
RF Exposure lnformation(if applicable) •DO NOT operale lhe radio without a proper antenna attached, as this may damage the radio and may also cause you to exceed RF exposure limits. A proper antenna is the antenna supplied with this『adio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this radio, and the antenna gain shall not exceed the specified gain by the manufacturer declared.
the time. To Transmit (Talk), push the Push to Talk ( PTT) button. To receive calls (listen), release the PTT button. Transmitting 50% of the time, or less, is , mportant because the radio generates measurable RF energy exposure only when transmitting in terms of measuring for standards compliance. •Transmit only when people outside the vehicle are at least the recommended minimum lateral distance away from a properly installed according to installat,on instructions, externally mounted antenna.
Electromagnetic Interference/Compatibility NOTE: Nearly every electronic device is susceptible to electromagnetic interference (EMI) if inadequately shielded, designed, or otherwise configured for electromagnetic compatibility or heallh care facilities (Pacemakers, Hearing Aids and Olher Medical Devices) may be using equipmenl lhat is sensilive to exlemal RF energy.
Safety Operation Avoid Burns 心笠它 �� • 立了 心;?驾滥盓它豆 any portable radio that has a damaged antenna. If a damaged antenna WARNING comes into contact with the skin when the radio is in use, a minor burn can result Batteries (If appropriate) •When the conductive mate rial such as jewelry, keys or chains touch exposed te rminals of the batteries, may complete an electrical circuit (short circuit the batte ry) and become hot to cause bodily injury such as bums.