Operation Guide 2.
INSTALLATION 1. Load the universal bracket to the camera as the following diagram, rs ‘Io the bottom of camera To the back of camera (optionally) 2. Connect the antenna fo the camera, 3. Locate the camera to a specific position and then adjust it to a suitable angle.
CAMERA CHANNEL SETUP You could adjust the channel switch to set the channel of camera for multi-carrier working or avoiding the interference, The steps are as the following, 1. Pull out the hood as the shown direction al 2.
4, Adjust the channel switch as the following diagram, Channel Switch Setup Diagram CH1 CH2 CH3 CHAR CAUTIONS # ‘The apparatus shall not be exposed to dripping or splashing and that no architects filled with liquids, such as vases, shall be placed on the appraises # ‘Turn off the Camera Receiver i the sienna is not in nse eo The adapter {8 used as the disconnect device from the mans The adapter shall rerun readily operable & The Cameraperson can only be completely disconnected from the mains by unpleasing t