Operation Guide 2.4GHz Wireless Camera Model: z-850T ECC Statement: This: device complies with Part 15 the FCC Rules. Operation is subject tithe following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Motion Alarm Setup: It fevers to the alarm against cations movements. If vou slide the alarm setting switch to IR position the alarm indicator lights up preen for 10s and then extinguishes to reset for 10s A afterward the system enters the alarm stat -by mode.
CONTENTS Packing List ET 1 850M B50M Structure RIVERBED roommate 3 Installation 4 ‘Table Installation of Er 4 Wall Installation of Camera Receiver Installation of CHITCHAT wo EE EN Camera Channel Setup vrs chess 10 Camera Alarm Setup 0 10 Receiver Mode Control Setup woos ms iz Cautions 13
STRUCTURE CAMERA ZT-850T 4 ™\ Antenna Alarm Setting Alarm Indicator Switch Infrared Lights Lens Motion Detection Sensor Power Socket Power Indicator — . Base i mes Power Switch Channel Batter Switch ~~ Barney compartment Power Jack \ PF.
INSTALLATION Table Installation of Camera 1. Connect the camera to the adapter (DC 8V 300mA) and then slide the power switch to ON position. The power indicator lights up. Notes: ¢ This camera can also work on dry battery (the wall location excludes dry battery use); please load 4 AAA batteries to the battery compartment at the bottom of camera with their polarities matched.
® The AC adapter-will work instead of batteries after it is plugged. If the camera is left tin used for a long period of time, please unplug the adapter and remove the batteries, 2. Rotate the camera toa suitable-angle for surveillance: Wall Installation of Camera The camera can also be mounted ontostheswallwithithe hanging bracket, The steps of installation are as follows: 1.
4, Connect the camera do the adapter. The power indicator lights op.
CAMERA CHANNEL SETUP Remove the base of the camera and vou will notice the channel switch marked with 1-2-3. Any one of them can be selected separately forth purpose of the milt camera working elevation or interference avoidance, CH: 2.41402 CHESS: 2.