User's Manual

ManualsBrandsShenzhen AEE Aviation Technology ManualsElectronicsHand Gimbal

Slate Elite

Quick Start Guide

Slate Elite is a self-stabilizing hand-held three-axis gimbal camera that can be used to

shoot high-definition videos and take high-definition photos, and realtime preview is

possible when the App is used as a viewfinder.

1. Power status indicator

2. Working status indicator

3. Joystick

4. Charging port

5. Power key

6. Video recording key

7. Shutter key

8. MicroSD card slot

9. Micro USB

10. Lens

11. Gimbal clamping ring

12. Mode switching key

13. Disk gear

14. Strap hole

15. Panning axis motor

16. Mobile device bracket

17. Bracket nut

18. Battery chamber lid

Summary of content (5 pages)

PAGE 1
Slate Elite Quick Start Guide Slate Elite is a self-stabilizing hand-held three-axis gimbal camera that can be used to shoot high-definition videos and take high-definition photos, and realtime preview is possible when the App is used as a viewfinder. 1. Power status indicator 2. Working status indicator 3. Joystick 4. Charging port 5. Power key 6. Video recording key 7. Shutter key 8. MicroSD card slot 9. Micro USB 10. Lens 11. Gimbal clamping ring 12. Mode switching key 13. Disk gear 14. Strap hole 15.
PAGE 2
English 1. Installing the battery and charging • Switch the unlock key on the battery chamber lid to “ ”, and then push the battery chamber lid towards the mark “OPEN”. Vertically place the battery in the battery chamber, and close the battery chamber lid. • Please use a standard adapter and data cable to connect to the charging port to charge the gimbal. During charging, the red indicator will flash slowly. When charging is completed, the red indicator will remain lit. 2.
PAGE 3
5. Operating instructions • Joystick: Move the joystick up, down, right, or left to control the rotation of the gimbal. • Video recording key: Press this key briefly to start video recording. Press it briefly again to stop video recording. • Shutter key: Press the photographing key briefly to photograph. 6. Switching between modes • Pressing and holding: The camera lens will remain facing towards the current direction.
PAGE 4
Technical specifications Gimbal head Power input: AC100-240V 50/60Hz Power output: DC12.
PAGE 5
Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.