AEE A10 Aerial photography equipment
Components (1) Blade × 4 (4) Undercarriage (7) IR obstacle avoidance sensor × 4 (2) Battery compartment (5) Lens (8) TF card slot (3) Optical flow module (bottom) (6) Power switch (9) Micro USB port Working Temperature:0℃~50℃. I. APP Installation 1. Where to Download Search the latest APP on our official website. Scan the QR code for a link and follow the instructions to download and install AEE ZONE onto your mobile device. Download the APP from an APP market: ** Android 4.
Step 1: Enable the Wi-Fi function of the mobile phone and find the relevant hotspot as shown in Fig. 2. Enter the password “00000000” and tap [Connect]. Fig. 2 Fig. 3 Step 2: Visit the downloaded AEE ZONE as shown in Fig. 3 and select the relevant interface for connection. Step 3: Preview the main interface as shown in Fig. 4. Fig. 4 Step 4: Tap the shooting/recording mode icon and select a mode as shown in Fig. 5. Fig. 5 III. APP’s Main Interface No.
5 IR sensor on/off 6 Quick takeoff/landing 7 Select a shooting/recording mode: 4 modes available 8 Wi-Fi signal 9 Battery level 10 Settings 11 Start shooting/recording 12 Switch the nose direction 13 Album IV. Charging The battery level is indicated by the battery level icon on the APP. Follow the figure below to charge the battery when the battery level icon shows less than one bar of power: Insert the battery into the Blue: charging status indicator. special charging base.
(1) Prepare the UAV: Keep the UAV in horizontal condition. (2) Adjust the camera’s pitch angle: As shown in the figure below, the camera supports 5 pitch angles: 0°(the lens faces the front), 15°in elevation (push the lens up), or -30°, -60°or -90°in depression (push the lens down). (3) Power on the UAV: Long press the power switch for 3s until the red power indicator is turned on. (4) Start the flight: (a) Take Off / Land Tap the quick takeoff/landing icon “ ”, and the UAV will take off to the 1.
2. Select the target photos/videos and download them onto your mobile phone as shown in the right figure above. 3. Exit to the interface as shown in the left figure below and tap [Album]. 4. Enter the local album as shown in the right figure above. 5. Select the photos to be shared and tap [Share] at the lower right corner to share them as shown below. VIII. Calibration Generally the UAV requires no calibration. However, please calibrate it if the UAV deflects or shakes.
In case of successful calibration, the power indicator will remain on without flashing. If the power indicator still flashes 20s later, it means the calibration fails. Power off the UAV and then restart it. If the power indicator still flashes, recalibrate the UAV. IX. Notes 1. Use the UAV in an indoor environment with calm air. 2. Disable the obstacle avoidance function in a narrow space. 3. If the image received from the UAV is displayed on the APP in an unsmooth or highly delayed way, restart the APP.
6. The UAV will be forced to land for safety sake in case of low battery power. 7. Charge the battery for 2h at most. Overcharging may damage the battery severely. 8. Over-discharging may shorten the battery’s service life severely. Please charge the battery in time. 9. Remove it from the UAV or charger immediately and stop using it if the battery smells, overheats, deforms, discolors or has any other anomaly. 10.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.