Wireless Smart Battery Camera Operation Instruction v1.
Contents 1.Packing list 01 2.Product appearance 02 3.Quick start 05 4.Install the camera 07 5.Power on/off and network configuration 09 6.Charge the camera 10 7.Indicator light status 10 8.Product specification 11 9.Firmware update 12 10. FCC warning 12 11.
Packing list Product appearance 1. Camera*1 2. Bracket*1 3. 3M Adhesive tape*1 4. Mounting kit*1 5. USB charging cable *1 Microphone White light Infrared lamp Indicator light Ambient light sensor Human body infrared sensor 6.
Threaded bracket interface Strong magnetic chuck Speaker Press buttons on both sides, and pull out the back cover.
Quick start 2. Add the device The wireless smart battery camera supports battery-powered supply and AC-powered supply. Sign in to Vicoo App，connect to Wi-Fi and add the device according to the prompts (please bring the device close to the router when configuring). 1. Download and install the App The wireless smart battery camera supports Android and iOS App.
Install the camera (2) Install the bracket You can place the camera on a shelf or other surfaces to use, or you can install it on a wall to use. 1).3M adhesive fixing: (1) Select a good spot for your camera Please install the camera in a position where its view is not blocked and ensure that it is within the coverage of the Wi-Fi network. Remove the protective film on one side of the 3M adhesive and stick it to the mounting surface of the bracket.
(3) Adjust the angle Charge the camera Attach the camera to the magnetic bracket, then adjust the surveillance angle. Vicoo App will remind you to charge your camera when the battery is low. Please use the Micro-USB cable to plug into the 5V/1.5A charging adapter to charge the camera. During charging, the camera's indicator light is solid yellow, and when the camera is fully charged, the indicator light will turn into solid green. It will take 8 hours to fully charge the camera.
Product specification Item Specification Camera lens Field of view: 110° Image resolution Max. 1920 X 1080 Video bit rate Adaptive Storage media Micro SD card (Up to 128GB) Battery capacity 5200mAh Adapter requirement 5V/1.5A Size 84*62*96(mm*mm*mm) * Up to six months in standby mode �� Firmware upgrade When you connect your camera through the Vicoo App, it will prompt you if the latest firmware is available. You can also manually check the firmware upgrade in the settings of the App.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
3.Q:Will the camera show red lights when night vision is activated? 6.Q:What is the maximum length of recording time? A:The built-in infrared lamp beads make the camera only show some dim red lights when night vision is activated, but the image quality is still clear under no light environment. A:You can choose the recording time in the app. The camera can record for a fixed time or “auto”mode, which depending on whether there is a person. The maximum length of a video is 3 minutes. 4.
