User Manual

ManualsBrandsShen Zhen Han Ma Shi Ji TECHNOLOGY ManualsElectronicsCeiling Fan Remote Control Kit

Installation Attention: Before contacting the seller,Please Check the following steps to get a quick solution:

1, !!!!! Turn off the power to the fan at the breaker before doing anything!!!!! A. Is there a wall switch or pull chain to the control unit?

2, Electrical installation should be performed by licensed electrician. B,Are the wires connected all right?

3, Spliced conductors should be turned upward and pushed carefully up into the outlet box. C,Are the batteries in the remote fresh?

4, Install the transmitter with the flat part up, so the ceiling fan cover is easier to close back in place. D,Whether there are other RF remote controller products nearby and working?

!!!If both the fan and the lamp are equipped with a switch, please switch the fan to the highest speed and The RF remote controlled products with the same frequency may disturb each other

turn on the lamp before use of the remote control.(Put the pull chain at the max speed) when working in close RF range.

Specification:

InputVoltage

ControlMethods

WirelessTransmission

MaxPowerforFan

MaxPowerforLight

3FanSpeedsControl

FanTiming

FanSpinReverse

LightDimming

Note: Not all ceiling fan have same color wires.Please check which wire is Fan, light and Neutral

carefully before install.

Wiring Diagram of Receiver Istallation Diagram of Receiver

INSTALLATION STEP:

1, Connect the wires

Notice: 2, Power On, you will hear a short sound beep from transmitter. Then the light should be o

1, The inputs and outputs of the receiver can not be connected reverse. automatically. The fan will not on.

2, Check the dimension of receiver carefully to make sure there is enough space in the canopy of your fan 3, Press fan speed button, control the fan.

3,Press every button on the remot to check if there are any response from the transmitter. The transmitter

should be beep when you press any buttons. If there are no beeps, please contact seller for technical support

NoDimming

Fan Lamp Remote Controller User Manual

110V

RF433MHz

REMOTE

145W

500W(Incandescent)/150W(LED)

High/Med/Low

1H/2H/4H/8H

Summary of content (2 pages)

PAGE 1
Fan Lamp Remote Controller User Manual Installation Attention: Before contacting the seller,Please Check the following steps to get a quick solution: 1, !!!!! Turn off the power to the fan at the breaker before doing anything!!!!! A. Is there a wall switch or pull chain to the control unit? 2, Electrical installation should be performed by licensed electrician. B,Are the wires connected all right? 3, Spliced conductors should be turned upward and pushed carefully up into the outlet box.
PAGE 2
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.