AN-CPAL45 Plus Cell Phone Signal Booster User Manual 1/9
Introduction With the popularity of mobile communications, people want to make a call anytime, anywhere, so the coverage requirement of communication network is higher and higher, but the reality is not so, sometimes mobile phone signal is not very good, you want to make a smooth call, even in some places cell phone cannot dial out. in this cases, cell phone signal booster can solve this problem in a certain extent.
-- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules.
Name Indoor Antenna Patch Antenna Model Gain/Loss PTE-PA-800-2500 3dbi @698-787MHz 3dbi @824-894MHz 3.5dbi @1850-1990MHz 3.5dbi @1710-2155MHz Indoor Panel PTE-PN-800-2500 Antenna 7dbi @698-787MHz 7dbi @824-894MHz 8.5dbi @1850-1990MHz 8.5dbi @1710-2155MHz Outdoor Omni Tube Antenna PTE-GF-700-2500 3dbi @698-787MHz 3dbi @824-894MHz Antenna 5dbi @1710-1755MHz 5dbi @1850-1990MHz 5dbi @2110-2155MHz Magnet Antenna PTE-MA-800-2500 3dbi @698-787MHz 3dbi @824-894MHz 3.5dbi @1850-1990MHz 3.
modified without the approval of the ANNTLENT company, otherwise it shall be deemed invalid. INSTALLATION INSTRUCTIONS (1)Installation of Outdoor Antenna The outside antenna comes with a strong magnet, simply put it on the roof of your vehicle. Run the cable of the outside antenna from the nearest door to the booster and connect the connectors by hand, please do not use any tools, otherwise it will be over installed to break the connectors.
TROUBLESHOOTING AND SUPPORT Problem Resolution LED is not light 1.Find an alternate DC Car Charge and try again. 2.Check the power outlet, the power adapter plug maybe is poor connected. 3.If the problem is still not solved, please contact our company support at support@ANNTLENT.com Booster has no 1. Check whether the direction of the booster is worng connected. 2. Make a call to your mobile phone operator to determine if the frequency band is correct. 3.
A subscriber must have the consent of a wireless provider to operate a Consumer Signal Booster. Subscribers may obtain provider consent in a variety of ways. For example, AT&T, Sprint, T–Mobile, and Verizon Wireless have voluntarily committed to allow their subscribers to use properly certificated Consumer Signal Boosters (i.e., boosters that meet the new rules) on their networks.
(http://www.uscellular.com/uscellular/support/fcc-booster-registration.jsp). WARRANTY Warranty information applicable to your Booster Warranty Period: 2 year. Type of Warranty Service: Customer Replaceable Unit and Customer Carry-In or Mail-In Service. ANNTLENT Company is not responsible for Shipping Cost. For Warranty service consult the telephone list at www.ANNTLENT-tech.com/contact us.
d'Innovation, Sciences et Développement économique Canada. L'exploitation est autori sée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même s i le brouillage est susceptible d'en compromettre le fonctionnement. Vous devez utiliser cet appareil avec des antennes et des câbles approuvés comme spécifié par le fabricant.