AN-L70V Plus Cell Phone Signal Booster User Manual 1 / 11
Introduction With the popularity of mobile communications, people want to make a call anytime, anywhere, so the coverage requirement of communication network is higher and higher, but the reality is not so, sometimes mobile phone signal is not very good, you want to make a smooth call, even in some places cell phone cannot dial out. in this cases, cell phone signal booster can solve this problem in a certain extent.
-- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules.
LED Booster working conditions Indicator LED LIGHT Continuous GREEN @normal; Twinkly GREEN @input signals may be not enough; Continuous YELLOW @ stronger input signals, AGC is working; Twinkly YELLOW@ self–oscillation happen ,AGC is working. Continuous RED@ power supply is shut down; Twinkly RED@ self–oscillation happen but power supply is NOT shut down. ②Power supply jack: The booster uses a power input range of DC 5-12V.
Outdoor Cable 50 feet 3D-FB Coaxial PTE-3D-FB-10NB 5.21db @746-787MHz cable with N male connector Notes:The above model antennas are suitable for AN-L70V Plus booster. Warning:Unauthorized antennas,cables and/or coupling devices are prohibited by FCC rules. Please contact FCC for details:1-888-CALL-FCC The antenna, cables, and other accessories of the booster kits shall not be modified without the approval of the ANNTLENT company, otherwise it shall be deemed invalid.
The mobile phone shall display full bar signals in location where the outdoor antenna is installed The phone calls or data transmission shall be smooth and stable by 3 times testing in location where the outdoor antenna is to be installed As shown from the above illustration, testing the signals from A to E, and select a best place that displays full bar signals to install the outdoor antenna. Selecting the installation direction of outdoor antenna.
will finally come to shut off the booster system. If isolation can’t be achieved by the limited distance, the roof of the building or any other barriers can be used in between to increase isolation. Fix the donor antenna after selecting the best position, and adjust slightly its height or angles in order to get the signals with suitable input power level and calling quality. (2)Installation of Indoor Antenna Proper antennas shall be selected according to the site conditions and the requirement.
that owners could be subject to potential FCC enforcement action for noncompliance. (3)Booster Installation Do not place the equipment in direct sunlight or in an area that has abrupt temperature and humidity changes . it is suggested that the booster is installed in a cool,dry and ventilated room without erosive gas and smoke. Connect power adaptor to the booster,connect The other end of power adaptor to the power outlet. WARNING: The input voltage for the booster is 5~12V DC.
Mobile phone can receive full signal, but can not normally It Usually means that the booster is self-oscillated, please make the distance between the indoor and outdoor antenna as far as possible, it is better to use a wall or metal to Separate the indoor antenna and the out door antenna. make a call During using your Booster, if the Booster interferes with your radio or other electronic device, move the Booster further away from those devices, you might be able to solve it yourself.
authorization for use of a particular booster model on behalf of all subscribers of individual providers. Alternatively, a provider may specify a testing protocol that if satisfied would result in licensee consent to specific booster models. A subscriber may also seek a licensee’s express consent to operate a signal booster, e.g.
on your invoice or sales receipt is the date of installation unless ANNTLENT or your reseller informs you. This warranty does not cover the following: Failure resulting from misuse, accident, modification, unsuitable physical or operating environment, or improper maintenance by you; The warranty is voided by removal or alteration of identification labels on the Machine or its parts. Copyright Information © 2020 Copyright ANNTLENT Technology (Shenzhen) Co., Ltd.