Shearwell X6 Reader SDL330 Tel: 01643 841611 Fax: 01643 841628 Email: support@shearwell.co.uk Website: www.shearwell.co.uk Version 0.8 23.06.
Contents 1 Getting started 2 - Introduction - Power - Safety 2 2 3 2 Installation 5 3 Labels 6 4 Specification 7 - Technical - Environmental 7 7 5 Industry Standards 8 6 Support 9 Version 0.8 23.06.
1 Getting Started Introduction The Shearwell X6 reader (SDL330) is a Radiofrequency Identification (RFID) device. It is designed and manufactured by Shearwell Data Ltd, the market leader for cattle and sheep tags in the United Kingdom. The device is designed to read animal electronic identification (EID) tags in compliance with the international standards ISO 11784 and ISO 11785, which regulates the RFID of animals.
Safety Notice → The user should never operate the device in proximity (less than 20cm) to the head/torso → Point the reader away from the body when using. → Do not allow the reader to be submerged in water. → Store the reader in a dry place. → If needed, the reader may be cleaned using a damp cloth. → There are no serviceable parts inside the Shearwell X6 reader. o Do not attempt to repair or replace any part of the reader.
CAUTION - Under Industry Canada regulations, the SDL330’s radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain has been chosen so that the equivalent isotropically radiated power (E.I.R.P.) is not more than that necessary for successful communication.
2 Installation The Shearwell X6 reader is designed to be affixed to a Handheld Nautiz X6, via two screws located either side of the connection pins on the lower part of the casing. The casing must be opened in order to access these screws. CAUTION - To attach the Shearwell X6 Reader, please follow these instructions carefully. Failure to do so could result in irreparable damage to the circuitry. Shearwell Data Limited is not responsible for any damages caused by the user during installation. 1.
3 Labels The following symbols are displayed on the device labels and have also been placed in this User Manual for reference and description.
4 Specification Technical Specification Frequency 134.2 kHz Transponder Types HDX and FDX compliant according to ISO11784/11785 • 50 mm Ferrite Antenna (typical values) o 80 mm HDX transponders o 60 mm FDX-B transponders • Antenna length: 50mm Type of ferrite: ROD8/150-4B1 Number of coil turns: 35 Coil diameter: 8mm Wire: 175/0.04mm Silk covered litz wire Reading Range • Antenna • • • Interfaces Power Supply Power Consumption UART at 3.
5 Industry Standards International The SDL330 has full product certification from the International Electrotechnical Commission (IEC). Furthermore, the SDL330 complies with IEC 62638-1:2018 CB, a product safety standard that classifies energy sources and prescribes safeguards against those sources. Further safety testing confirmed compliance with EN 50364:2010, which concerns limitation of human exposure to electromagnetic fields from RFID devices.
6 Support Contacting Shearwell Data Limited If you would like further information or assistance than what is given in this manual, then you can contact Shearwell Data Limited in the following ways: Phone: +44 (0)1643 841611 Fax: +44 (0)1643 841628 Email: support@shearwell.co.uk Support lines are open: Mon-Fri 8am-5pm Version 0.8 23.06.2022 Address: Shearwell Data Ltd. Putham Wheddon Cross Minehead Somerset TA24 7AS Website: www.shearwell.co.