Operating Instructions

The artwork and design of this manual are protected by US copyright law and
may not be reproduced, distributed, displaced, published or used for any
purpose without prior written permission. Altering, removing or reproducing
any of the trademark or copyright notices on this package is not permitted.
Sharper Image® name and logo are registered trademarks. Distributed by
and © 2020 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
OPERATING INSTRUCTIONS
The car requires 6 AA (1.5V) alkaline batteries (not
included). The battery compartment is on the underside
of the vehicle. Loosen the screw using a phillips or cross
screwdriver to remove the battery cover. Insert the AA
batteries according to the diagram inside the battery
tray. Replace battery cover and tighten screws.
ii iiii iiiiii
Carefully remove items from package.
BATTERY WARNING:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable batteries.
• Alkaline batteries are recommended. Use only the
specified voltage.
• Insert batteries using the correct polarity. Always use,
replace, and recharge (if applicable) batteries under adult
supervision.
• Do not charge with non-rechargeable batteries.
• Do not short-circuit the battery supply terminals.
• Do not dispose of batteries in a fire, batteries may explode
or leak.
• Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state,
and local laws.
• Keep these instructions for future reference.
• Avoid water when operating.
• Do not submerge car or controller in water.
• Do not use people or animals as obstacles.
• Do not run car into furniture objects or hard surfaces as this
will cause damage to both the objects and car.
• Keep fingers, hair and loose clothing away from the tires, gears
and motor while car is switched to “ON”.
• Do not leave car or remote control near sources of heat or
under direct sunlight for long periods of time.
• Remove all batteries when not in use to avoid accidental
operation.
• Adult supervision is recommended when operating car.
• Thoroughly inspect products before every use. If the product
appears worn, frayed/splintered, cracked, or broken in any
manner, discontinue use and discard immediately.
Forward
Spinning Action
Tumbling
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the pictures on this manual may
dier slightly from the actual product.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
SAFETY PRECAUTIONS
1-800-374-2744
FOR TECHNICAL SUPPORT,
PLEASE CALL
6+
*Press and Hold
Reverse
*Press and Hold
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Printed in ChinaModel Number: 1014148
*Press and Hold
Note: for best operation, use vehicle on hard rough surface.
When the vehicle is moving
forward or backward and
push the stunt button, it will
cause it to flip over.
GLOW IN THE DARK ORBIT TUMBLER
The remote control requires 4 AA (1.5V) alkaline
batteries (not included). Loosen the screw at the
bottom of the remote using a phillips or cross
screwdriver to remove the battery cover. Insert the
batteries according to the diagram inside the battery
tray. Replace battery cover and tighten screw.
Battery
Compartment
Screw
Power Switch
Pairing:
The Orbit Tumbler and Remote must be paired before driving.
1. Rotate the remote power knob clockwise to turn on the remote. The status light on
the antenna cover will pulse.
2. Turn on Orbit Tumbler – its lights will flash rapidly.
3. The lights on the Orbit Tumbler and Remote will stop flashing when they are paired.
If you have more than one vehicle and remote, you must pair one first, and then you
may pair others.
Charging the Glow In The Dark Cage:
Place the Orbit Tumbler in direct sunlight for approximately 60 minutes. The cage will
now glow in the dark for up to 20 minutes.
Power
Knob
Left
Wheels
Right
Wheels
Stunt
Button
Status
Light