Service manual

ManualsBrandsSharp ManualsDomestic AppliancesR-2130

R-2130JS

In the interest of user-safety the oven should be restored to its original condition and only parts identical to those specified should

be used.

WARNING TO SERVICE PERSONNEL: Microwave ovens contain circuitry capable of producing very high voltage

and current. Contact with the following parts may result in a severe, possibly fatal, electrical shock. (Inverter unit

that includes High Voltage Capacitor, High Voltage Power Transformer, High Voltage Rectifier and Heat sink etc.,

and Magnetron, High Voltage Harness etc..)

S94M2R2130JS/

R-2130JS

OVER THE RANGE

MICROWAVE OVEN

MODEL

SUPPLEMENTAL SERVICE MANUAL

SHARP CORPORATION

This document has been published to be used for after

sales service only.

The contents are subject to change without notice.

TABLE OF CONTENTS

Page

PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO

AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY ................. INSIDE FRONT COVER

BEFORE SERVICING .................................................................................................... INSIDE FRONT COVER

WARNING TO SERVICE PERSONNEL .............................................................................................................. 1

MICROWAVE MEASUREMENT PROCEDURE.................................................................................................. 2

FOREWORD AND WARNING............................................................................................................................. 3

PRODUCT SPECIFICATIONS ............................................................................................................................ 4

PARTS LIST ........................................................................................................................................................ 7

PACKING AND ACCESSORIES ....................................................................................................................... 11

Summary of content (16 pages)

PAGE 1
R-2130JS SUPPLEMENTAL SERVICE MANUAL S94M2R2130JS/ OVER THE RANGE MICROWAVE OVEN MODEL R-2130JS In the interest of user-safety the oven should be restored to its original condition and only parts identical to those specified should be used. WARNING TO SERVICE PERSONNEL: Microwave ovens contain circuitry capable of producing very high voltage and current. Contact with the following parts may result in a severe, possibly fatal, electrical shock.
PAGE 2
R-2130JS PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY (a) Do not operate or allow the oven to be operated with the door open.
PAGE 3
R-2130JS WARNING TO SERVICE PERSONNEL Microwave ovens contain circuitry capable of producing very high voltage and current, contact with following parts may result in a severe, possibly fatal, electrical shock. (Example) Inverter unit that includes High Voltage Capacitor, High Voltage Power Transformer, High Voltage Rectifier, Heat sink etc., and Magnetron, High Voltage Harness etc.. Read the Service Manual carefully and follow all instructions. Don't Touch ! Danger High Voltage 1.
PAGE 4
R-2130JS SERVICING FOR INVERTER UNIT WARNING This inverter unit contains circuitry capable of producing high voltage and high current. Contact with any part of the high voltage will result in electrocution. DO NOT ACCESS ANY PARTS OF INVERTER UNIT WITH POWER SUPPLY CONNECTED. DO NOT OPERATE INVERTER UNIT ITSELF. It is dangerous because this unit contains high voltage components. MICROWAVE MEASUREMENT PROCEDURE A.
PAGE 5
R-2130JS SERVICE MANUAL PRODUCT DESCRIPTION OVER THE RANGE MICROWAVE OVEN R-2130JS GENERAL INFORMATION FOREWORD This Manual has been prepared to provide Sharp Electronics Corp. Service Personnel with Operation and Service Information for the SHARP OVER THE RANGE MICROWAVE OVEN, R-2130JS. It is recommended that service personnel carefully study the entire text of this manual so that they will be qualified to render satisfactory customer service. Check the interlock switches and the door seal carefully.
PAGE 6
R-2130JS PRODUCT SPECIFICATION ITEM DESCRIPTION Power Requirements 120 Volts / 14 Amperes 60 Hertz Single phase, 3 wire grounded Power Output 1200 watts (IEC TEST PROCEDURE) Operating frequency of 2450MHz Case Dimensions Width 29-15/16" Height 17" Depth 15- 9/16" Cooking Cavity Dimensions 2.1 Cubic Feet Width 22-9/16" Height 10-9/16" Depth 15" Hood lamp 2 bulbs, 20W x 2, Incandescent light bulbs Hood fan Approx. 300 C.F.M./ 270 C.F.M.
PAGE 7
R-2130JS GENERAL INFORMATION GROUNDING INSTRUCTIONS This oven is equipped with a three prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. WARNING: Improper use of the grounding plug can result in a risk of electric shock.
PAGE 8
R-2130JS R-2130JS NOTE: Some one-touch cooking features such as "MINUTE PLUS" are disabled after three minutes when the oven is not in use. These features are automatically enabled when the door is opened and closed or the STOP/ CLEAR pad is pressed.
PAGE 9
R-2130JS PARTS LIST Note: The parts marked “∆ ∆” may cause undue microwave exposure. The parts marked “*” are used in voltage more than 250V. REF. NO. PART NO.
PAGE 10
R-2130JS REF. NO. 4-15 4-16 4-17 4-18 4-19 4-20 4-21 4-22 4-23 4-24 4-25 4-26 4-27 4-28 4-29 4-30 4-31 PART NO.
PAGE 11
R-2130JS 2 1 4 3 6 5 OVEN AND CABINET PARTS 6-1-5 7-2 6-14 4-10 A A 7-2 7-2 1-12 4-3 7-2 2-1 7-2 1-3 7-7 4-29 B 7-7 7-2 7-2 2-5 1-14 B 4-12 7-2 6-16 7-2 7-2 4-19 4-30 4-2 C 1-8 2-9 7-2 1-7 4-16 2-6 7-2 6-16 7-7 4-13 C 7-2 7-7 6-10 1-13 4-18 1-5 7-3 4-20 4-2 D 4-31 1-11 7-2 7-3 D 1-9 4-7 4-16 6-8 4-11 4-21 1-1 4-13 6-12 4-26 7-3 E 4-27 7-4 E 7-6 4-28 1-2 4-26 7-7 7-4 2-2 2-3 7-5 4-22 4-4 4-4 6-8 7-4 7-8 1-4 4-15 7-1 7-9 1-6 7-9
PAGE 12
R-2130JS 2 1 4 3 6 5 4-1 DOOR PARTS 5-6 A A 5-3 5 5-7 5-1 5-7 5-7 B B 5-2 5-7 C C CONTROL PANEL PARTS 5-5 5-4 3-1 3-2 3-3 D D 3-4 3-2 3-5 E 3-2 7-2 MISCELLANEOUS E 3-6 3-2 6-1 6-1-1 6-1-4 6-1-5 3-8 F 6-1-2 F 6-1-6 3-7 6-1-7 6-1-3 3-9 6-19 6-2 3-10 G G 6-5 6-6 6-16 6-17 6-7 H H 1 2 4 3 10 5 6
PAGE 13
R-2130JS 2 1 4 3 6 5 PACKING AND ACCESSORIES 2-4 Bottom sash and 2-10 Bottom sash angle A A 6-17 SCALE PLATE (x 2) 6-13 GREASE FILTER (x 2) 6-2 Rack TOP PAD 6-4 TOP AND WALL TEMPLATE B 6-15 RECIPE CARD FOR R-2120JK/W 6-3 B OPERATION MANUAL DOOR PROTECTOR 6-1 INSTALL MATERIAL ASSEMBLY WRAP COVER 6-11 REAR CUSHION 6-14 EXHAUST DAMPER ASSEMBLY C C ACCESSORY PACK DOOR PAD D D BOTTOM PAD Non-replaceable items PACKING CASE E E F F G G H H 1 2 4 3 11 5 6
PAGE 14
R-2130JS NOTES 12
PAGE 15
R-2130JS NOTES 13
PAGE 16
R-2130JS COPYRIGHT © 2004 BY SHARP CORPORATION ALL RIGHTS RESERVED. No part of this publication may be reproduced, stored in retrieval systems, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of the publisher. 2004 SHARP CORP. (9S2.530E) Printed in U.S.