(1] Precautions s [2] Name of Contrails . .23 (3] power Sauce Radio Operation 56 (5 Inserting Cassatt Opes not expose the unit to yin or moisture, as this will result in damage to internal circuits, mDo not expose the unit to temperatures higher than §0°C {140°F}. This includes leaving the unit inside closed vehicles, placing it in direct sunlight or in the vicinity of heaters, etc. %00 not locate o store the unit for extended periods in places with high humidity of high concentrations of dust.
Volume Control: VOLUME External Microphone Sockets: EXT MiC Balance Control: BALANCE Built-in Microphone: MIC Tone Control: TONE Band Elector Switch: BAND Function Spectacular Prates Station Mamore Baristas: Switch: FUNCTION MEMO FM Mods Switch: Preset Tuning Buttons: FM MODE PRESET TUNING Tuning Controls: TUNE Preset Tuning Indicators: MEMORY Tuning Meter: TUNING METER Dial indicators FM Stereo Indicator: FM STEREO Cassatt Compartment Power indicator: Digital Tape Courser and POWER Tape Coulter Reset Butto
FM Telescopic Rod Antenna Headphones Socket: PHONES Beat Cancel Switch: BEAT CANCEL Battery Compartment AC Power Supply Sack at AC Supply Voltage Selector Be sure to sack the voltage setting of the voltage selector before connecting AC supply lead plug to the AC outlay, [f necessary, adjust the setting a5 follows: Loosen the securing resew of the supply voltage sector, 4 Slide the panel up or down, until the correct voltage reading is seen on other side. 3 secure the screw.
# Disconnect Main Battery Installation T Please lay the unit face down an a soft cloth 90 a5 not to damage the unfit. Remove the battery compartment cover, 2 overt six batteries into the battery rampart. men In numerical order as shown in the illustration, . Use either UM/SUM-2 or R14 batteries. insert batteries (@ and by pushing them toward the () terminal, 3 Replace the hatter compartment cover. Note: #!When batteries became weak, recording may become impossible, even though radio broad.
RADIO OPERATION Manual Tuning fth 7 set the FUNCTION switch to the RADIO position. 2 St she BAND switch ta the FM or MW position. 3 Adjust the aerie to obtain the best reception. (See the instructions on page 6.} 4 Press the TUNE contrails (UP or DOWN} until the required broadcast is received clearly. 1) Press the UP or DOWN button until tha dick indicator for the frequency range including the desired broadcast station fights up.
By pressing each PRESET TUNING button, the uni tune to ane FM station and one MW stain per by intact even ff the FUNCTION switch Is set to the P T Tune o the desired station, {Sec the instruction for Manual Tuning) 2 Press the MEMO button simultaneously. # At the time, press two points of the MEME button simultaneously. Otherwise, no memory operation is performed, express one of the PRESET TUNING buttons {1 10 6].
21 Inserting Full reel INSERTING CASSETTE TAPES Depress the STOP/EJECT =/4 bunion. insert the tape in the compartment so that the title of the tape track 10 be used is phasing outwards. 23 Close the compartment door. Unloading Depress the STOP/EJECT remove the taps.
‘ Set the FUNCTION switch to ths TAPE position, 2 insert the cassette ino the content encampment, 3 Depress the PLAY 4 button. 4 Adjust the VOLUME, BALANCE and TONE cantors, Bully-in loudness circulate: When listening to the radio or & taps at fow volumes settings, the builtin loudness circuit ik activated 10 compensate for bass and treble deficiencies. #since treble is emphasized on ‘tapes recorded with tha Dolby.
» Depress the STOP/EJECT m/4 button if the recorder is In a mode other than neutral. Fast Forward I order to rapidly advance the taps in the same direction as playback, depress the F FWD w butter. Rewind To rewind the tape in the opposite direction to playback, depress the REWIND » button. o When the end of the taps is reached in the st forward or rewind mode, the tape wail stop, but the motor will continue 1o rotate, Depress the STOP/EJECT m/a button immediately.
#Do not connect any plug to the EXT MIC (R and L) sockets during recording with the builtin microphone. # Monitoring of recording is not possible, ® Cording from the butt-in microphone is not in starter. T Set the FUNCTION singleton to the TAPE poi. son. 2 Turn the unit so that it is facing the sound saurian and lactate the unit for optimal reproduction, 3 Perform steps 2 10 4 and & of from the Built-in Mediocre.
7 Connect the microphone plugs ta the EXT MIC (R and L) sockets. Set the FUNCTION switch to the TAPE position, Perform steps 2 o 4 and 8 of “Recording farm the Build-in Randi” on page 9. » Microphones should have an impedance of 400 ohms to 3k ohms and be equipped with a 3.8 mm dismember plug. @ Monitoring of recording is nat passable. Note: Place the external microphone approx tamely 10 cm {47} to 15 em away from sound source.