PN-TPCi7W7 User Guide Version – 1
Getting Started Getting Started Introduction to PN-TPCi7W7 The PN-TPCi7W7 is a full-featured High Definition PC based upon Intel H67® architecture, and powered by an Intel® Core™ i7 CPU. Targeted for Commercial applications such as interactive digital white boards, the PN-TPCi7W7 has been optimized for reliable operation with Sharp® PN-L series touch screen displays. The PN-TPCi7W7 includes the Sharp Pen Software™ installer application loaded on the hard disk.
Getting Started Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Specifications Specifications Chipset o Intel® H67 Size o Mini-ITX form factor o Case: 7.5” x 7.4” x 1.75” Microprocessor support o Intel® Core™ i7-3770T® Quad-Core CPU @ 2.
Specifications Specifications (con’t) On board RealTek™ 8111E Gigabit LAN Chip o Supports 10/100/1000Mbps operation o 1 x RJ45 LAN Port Onboard Audio o RealTek™ ALC888S High-Definition audio chip o Supports up to 8-channel (2/4/5.1/7.
Specifications Specifications (con’t) Optional o Watchdog timer Environmental o Operating Temperature: 0° to 40° C o Operating Humidity: 80% maximum relative humidity, non-condensing Power o Input Voltage: 12V 7A o Power Dissipation: 70 Watts Wireless o WLAN 150Mbps o 2.4GHz 802.
Installation Mounting PN-TPCi7W7 on Sharp PN-L Series Displays 1. Before beginning Make sure to turn off the monitor and remove the AC power. 2. Items needed • • • • • • • Sharp PN-L Series Touch-Screen Display PN-TPCi7W7 Mounting Plate AC Power Adapter 4 x M4 (0.7x10mm) screws 2 x M3 (0.5x5 mm) Phillips® Screw Driver Figure 1 3. Attach the mounting plate There are 8 holes on the mounting plate, but only use 4 holes to match the monitor’s mounting holes depending on the monitor model.
Installation 4. Set the AC power adapter in place Place the AC power adapter into the holder on the right side of the mounting plate as in Figure 3. AC power cord faces downward and the DC power cord to the PN-TPCi7W7 faces upward. Figure 3 5.
Installation There are two fingers on the left side of the mounting plate to catch the PN-TPCi7W7 in place as shown in Figure 6, and they need to be tightened with two include M3 screws. Figure 6 6. Connect the HDMI video cable and the USB cable prior to turning on the PN-TPCi7W7. 7. Finish Plug in the DC power cord into the PN-TPCi7W7’s power connector as in Figure 7.
Installation Rear Connector Layout Audio Port 2-Channel 4-Channel Blue Green Pink Orange Black Grey Line-In Line-Out Mic In N/A N/A N/A Audio Port 7.1-Channel Blue Green Pink Orange Black Grey Line-In Front Speaker Out Mic In N/A Rear Speaker Out N/A 5.
Installation Rear Connector Layout (con’t) 1. Power Connection (refer to the figure in the previous page) Use only the AC power adapter supplied with the system. Input: 100~240V AC 1.3A Output: 12V DC 7A Plug the 12V AC/DC adapter (as in the figure 1 above) to the PNTPCi7W7’s power input jack (as in the figure 2). 2. Power Button This button will stay lit if the PN-TPCi7W7 is powered on. If the PN-TPCi7W7 doesn’t power up after the AC is connected, then press this button to power up.
Installation How to Recover to Factory Installed Condition 1. Before beginning Make sure that all the data including contents and programs you installed are backed up. If you are trying to recover from a bad HDD, please have a qualified technician runs diagnostics and replaces defective components. If the unit is in warranty, please contact Sharp Customer Service. 2. Items needed Recovery DVD (comes with the unit) USB DVD Drive 3.
End Support & RMA Warranty service is available from a Sharp® Authorized Service Center located in the United States. To receive repair handling instructions and to find the location of the nearest Sharp Authorized Service Center, please call Sharp toll free at 1-800-BE-SHARP (1-800-237-4277). If it is necessary to ship the Product for servicing, please be sure it is insured and packaged securely.
