Installation guide

ManualsBrandsSharp ManualsMicrowaveOfficial Sharp electric range with microwave drawer

30"Slide-in Range

INSTALLATIONANDSERVICEMUSTDEPERFORMEDBYAQUALiFiEDINSTALLER,

iMPORTANT: SAVE THiS INSTALLATION MANUAL FOR LOCALELECTRICAL

iNSPECTOR'S USE,

READANDSAVETHESEINSTRUCTIONSFORFUTUREREFERENCE,

For SAFETY CONSiDERATiONS do not instaJJa appJiance in any combustibJe cabinetry which is not

in accord with the stated clearances and dimensions on page 2. See Figures 1 and 2.

RANGEMEASUREMENTS...................................... 2

CLEARANCESANDDiMENSiONS.............................. 2

iMPORTANTNOTES............................................. 3

UNPACKINGANDEXAMiNiNGYOURRANGE................. 3

iMPORTANTSAFETYiNSTRUCTiONS......................... 3

ELECTRICAL CONNECTIONS ................................ 4=6

MODELANDSERIALNUMBERLOCATION.................... 4

ANTI-TIP ..................................................... 6-8

CANE,CLEANINGANDMAINTENANCE...................... 8

¸¸¸¸¸¸;¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸2¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸.¸¸¸¸¸¸¸¸¸¸¸¸¸¸....

® Insight '_

Summary of content (8 pages)

PAGE 1
30" Slide-in Range INSTALLATION ANDSERVICEMUSTDEPERFORMED BYA QUALiFiED INSTALLER, iMPORTANT: SAVE THiS INSTALLATION MANUAL FOR LOCAL ELECTRICAL iNSPECTOR'S USE, READANDSAVETHESEINSTRUCTIONSFORFUTUREREFERENCE, For SAFETY CONSiDERATiONS do not instaJJa appJiance in any combustibJe cabinetry in accord with the stated clearances and dimensions on page 2. See Figures 1 and 2. which is not RANGEMEASUREMENTS ...................................... 2 ELECTRICAL CLEARANCES ANDDiMENSiONS......................
PAGE 2
iNSTALLATiON MANUAL 31 1/4" glass end control panel If using countertop with integrated drip edge, remove 5/8" to make flush as illustrated. 29 7/8" 5/8" min. minimum 30" to bottom of cabinet over 18" to upper 36" cabinets to bottom of cooktop surfece 36 _' countertop height door width Figure 1 contains many range measurements planning your kitchen and/or range location. for reference when Maximum depth of cord, plug and receptacle box is 4" to prevent interference with lower oven.
PAGE 3
iNSTALLATiON _To • Read alloftheInstallation Manual before installing therange. ° Remove allpacking material fromtheoven anddrawer before connecting theelectrical supply totherange. • Observe allgoverning codes andordinances. • Besuretoleave these instructions withtheconsumer. MANUAL reduce the risk of tipping be secured the range.
PAGE 4
iNSTALLATiON MANUAL 2081240 VOLT CONNECTION iNSTRUCTIONS The range can be set for 208V or 240V. The voltage setting for your range is pre-set at 240V from the factory. Follow these steps to change the voltage setting. The installer or consumer is responsible for connecting the power supply cord to the connection block located behind the back panel access cover.
PAGE 5
iNSTALLATiON 4-W|RE CONNECTION center, lowest screw. See Figure 10. The ground strap must not be removed unless National, State or Local Codes do not permit use of a ground strap. iNSTRUCTiONS If the ground Before wiring the range, review the suggested power source location drawing in Figure 2. If connecting to a 4-wire electrical system %r a new branch-circuit or mobile home use a 4-wire connection.
PAGE 6
INSTALLATION MANUAL _ln°Ck'"_ terminal line2 _=_ 1_ _round plate ground screw / / Figure t t Figure NORMAL ANTI-TIP INSTALLATION BRACKET IMPORTANT To reduce STEPS INSTALLATION SAFETY iNSTRUCTiONS e WARNING the risk of tipping of the range, the range to the floor by properly installed Anti-Tip with the range.
PAGE 7
|NSTALLAT|ON • max 11/4" leveling leg MANUAL Adjust the back leveling legs with an adjustable wrench or pliers. Measure from the floor to the bottom of the cooktop glass (X) and adjust the legs to match the measurement (Y) taken from the cutout. See Figure 17. wall mount wa I floor Figure \ mount _Anti-Tip ate v/, bracket floor to top t 4 I I-- movethan leveling leg 1114" Figure • wail floor Figure mount off cooktop glass _ _ v t7 After leveling, tighten the lock nuts on the rear to
PAGE 8
iNSTALLATiON MANUAL Visually check that rear leveling leg is inserted into and fully secured by the Anti-Tip bracket by looking underneath the range with a flashlight and carefully attempt to tilt it forward. Slide range into cabinet until control panel edge is flush with the countertop Figure front edge. 20 Refer to the Operation Manual for cleaning instructions. If removing the range is necessary for cleaning or maintenance, disconnect the electrical power supply.