MUSIC SYSTEM FOR iPod MODEL DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) OPERATION MANUAL iPod is a trademark of Apple Inc., registered in the U.S. and other countries. Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product.
ENGLISH DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) ENGLISH Special notes Warning: z When the unit is set at STAND-BY mode, mains voltage is still present inside the unit. General Information z This unit contains no user serviceable parts. Never remove covers unless qualified to do so. This unit contains dangerous voltages, always remove mains plug from the socket before any service operation and when not in use for a long period. z The supplied AC/DC adaptor contains no user serviceable parts.
Accessories DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) Contents Please confirm that only the following accessories are included. General Information Page ENGLISH Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Controls and indicators . . . . . . . . . . . . . . . . . . . . . . 4 - 5 Preparation for Use AC/DC adaptor x 1 AC/DC adaptor x 1 (for Australia only) System connections . . . . . . . . . . . . . . . . . . . . . . . .
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) ENGLISH Precautions General z Please ensure that the equipment is positioned in a well-ventilated area and ensure that there is at least 10 cm (4") of free space along the sides, top and back of the equipment. General Information z Use the unit on a firm, level surface z Hold the AC/DC adaptor by the head when removing it from the wall socket, as pulling the lead can damage internal wires.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) Controls and indicators 4 2.1 STEREO SPEAKER BUILT-IN SUBWOOFER 1 2 Reference page iPod Dock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 ESOUND/TV Out Button. . . . . . . . . . . . . . . . . . . . . . . . . 8 Volume Down Button . . . . . . . . . . . . . . . . . . . . . . . . . 8 Subwoofer Duct . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 ON/STAND-BY Button . . . . . . . . . . . . . . . . . . . . . . . . . .
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) Controls and indicators (continued) ENGLISH General Information The spec label (*) 1 The spec label illustration may be different from the actual label used. (*) Label is located at the bottom of the unit. 1. Bottom View Reference page Battery Compartment . . . . . . . . . . . . . . . . . . . . . . . . 7 E-5 DK-AP7N_A6_EN_SCA.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) System connections Connecting iPod to TV Photo and video files from iPod can be viewed by connecting the system to TV/monitor. If the TV/monitor has a video input, connect it to the VIDEO OUT socket at the back of the unit and set the TV Out on the iPod unit to “ON” position.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) ENGLISH System connections (continued) Using with the batteries Preparation for Use Use 4 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar). Batteries are not included. 1 Open the battery cover. Slide the cover in the direction of the arrow. 2 Insert the batteries according to the direction indicated in the battery compartment. 3 Close the cover.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) General control 2.1 Volume control ENGLISH Press the VOL (+ or –) button to increase or decrease the volume. POWER indicator will be blinking when the volume reaches maximum or minimum level. STEREO SPEAKER BUILT-IN SUBWOOFER ESOUND control When ON/STAND-BY button is pressed, the ESOUND indicator turns yellowish orange. You are now in the ESOUND mode, where low bass and high frequency are automatically adjusted according to the volume input.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) ENGLISH Listening to the iPod Supported iPod models: z iPod nano (software 1.2 above) z iPod mini (software 1.2 above) z iPod (5th generation) (software 1.3 above) (Dock connector equipped Click Wheel model) z iPod (4th generation) (software 3.0.2 above) (Dock connector equipped Click Wheel model) z iPod nano (2nd generation) (software 1.0.0 above) z iPod nano (3rd generation) (software 1.0.3 above) z iPod nano (4th generation) (software 1.0.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) To insert iPod adaptor 1. Insert the iPod adaptor into unit and connect your iPod. iPod (bottom) iPod 1 2 3 ENGLISH iPod playback Press the ON/STAND-BY button to turn the power on. Insert iPod unit in the iPod dock of main unit. Press the playback. button on the iPod unit to start For iPod touch, playback will automatically start once the desired file is selected.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) ENGLISH Enhancing your system The audio cable is not included. Purchase a separate audio cable as shown below. Portable audio player AUX IN Advanced Feature Computer To the line output socket Listening to the audio/video sounds from portable audio player, computer, etc. 1 Use Audio cable to connect the portable audio player, computer etc. to the AUX IN socket. When using video equipment, connect the audio output to this unit and the video output to a television.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) Troubleshooting chart General Symptom z When a button is pressed, the unit does not respond. z No sound is heard. Symptom z No sound is produced. No image appears on the TV/monitor. Possible cause z z z z z Set the unit to the power stand-by mode and then turn it back on. z Is the volume level set to ENGLISH iPod z z iPod will not charge. z minimum? z z Possible cause The iPod is not playing. The iPod is not properly connected to the unit.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) ENGLISH Maintenance Condensation Sudden temperature changes, storage or operation in an extremely humid environment may cause condensation inside the cabinet. Condensation can cause the unit to malfunction. If this happens, leave the power on until normal playback is possible (about 1 hour) before operating the unit. References Cleaning the unit Periodically wipe the unit with a clean soft cloth.
DK-AP7N(R) DK-AP7N(S) DK-AP7N(W) Specifications ENGLISH Output terminals Video output: 1Vp-p Input terminals Auxiliary (audio signal): 500 mV/47 k ohms Dimensions Width: 198 mm (7-4/5") Height: 69.8 mm (2-7/10") Depth: 77 mm (3") Weight 0.59 kg (1.3 lbs.) General Power source DC IN 6V 2A: AC/DC adaptor (AC 100 - 240 V ~ 50/60 Hz) DC IN 6V [ “AA” size (UM/SUM-3, R6 or HP-7) battery x 4] Power consumption Power on: 5 W Power stand-by: 0.6 W(*) Output power Front speakers: MPO: 3.04 W (1.
SHARP CORPORATION TINSEA285AWZZ 09D R KI 1